HG/T 3146-1985 Flat bottom and removable flat cover storage tank series

Original standard number HG 5-1572-1985 HG/T 3146-1985 Flat bottom and removable flat cover storage tank series HG/T3146-1985 Standard download decompression password: www.bzxz.net

The design pressure of this standard series is pressurized (referring to the highest wave surface partial pressure of the gas phase space of the storage tank is not more than 200mmHz0), the design temperature is 0℃≤≤200℃, and the nominal volume V. 0.1～1.5m2. 1 Type, basic parameters and dimensions
Structural type (see Figure 1 and Table 1
The Ministry of Chemical Industry of the People's Republic of China 1985-11-13 issued 1985-12-01 implementation
Standard number
GB 30 76
GE 52—76
Basic parameters and dimensions (see Table 2)
Volume.m2
2 Installation requirements
HG 5—1572—85
Details
Bolt M20×45
Nut 20Www.bzxZ.net
Inch, mm
2.1 The storage tanks of this standard series should be placed on the flat foundation 1:. #Diameter
See wheat 2
See Table 2
Original Institute
Rubber asbestos board
Standard serial number
HG5-1572--85-1
HG6—1572—85-2
HG 5- 1572—85 -3
1.5175IIG5—1573—85-4
240HG5—1572—85-5
HG 5-1572~ 85 -6
51572-85-7
HG 5—1572 --85
2.2 For tanks placed on wall racks or steel racks, the support spacing should be in accordance with the requirements of Figure 2: (in the figure, A -0.6DB -0.8D)
3 Marking example
For a tank with a nominal volume V: = 0.1m3 and a nominal diameter O = 500mm, the specified marking code is: Yao L - C -0. 1 - 500 HG 5—1572-85 -4 Technical requirements
Should comply with the provisions of HG5-1571-85 (Classification and Technical Conditions of Standard Series for Ordinary Carbon Steel and Low Alloy Steel). 5 Selection Instructions
5.1 When selecting a storage tank in this standard series, fill in the "Tank Ordering Conditions Table" (see Appendix A) according to the use requirements. 5.2 The tanks in this standard series shall be equipped with manholes (handholes) and connections as required, and their number, specifications, orientation and specifications shall be filled in the "Tank Ordering Conditions Table". 5.3 The implementation drawings of this standard series shall be drawn by the design unit or manufacturer according to the parameters in this standard series. Drawing
Taiwan Garden Square Department
Additional instructions:
HG 5-1572 -85
This standard was proposed and managed by the Chemical Machinery Research Institute of the Ministry of Chemical Industry. This standard was drafted by Beijing Shishan Chemical Engineering Company of China Petrochemical Corporation and Shanghai Chemical Machinery No. 1. The main drafters of this standard are Po Zhihong, Lan Wenqing, Chang Caifeng, Li Xianting, Wu Zhixian and Sheng Wenlan.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.