INdex
GB standard
Standard category
Machinery Industry
It standard
Industry Standard
Chemical Industry It standard Petrochemical ZB Industry Light industry Railway industry Shipping industry Measurement standards

JB/T 8027.1-1999 Machine tool fixture parts and component supports

time: 1999-08-06 15:00:00
  • JB/T 8027.1-1999
  • in force

Basic Information

standard classification number

  • Standard ICS number:

    General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)

  • China Standard Classification Number:

    Machinery>>Process Equipment>>J44 General Fixture

associated standards

Publication information

Other Information

  • Focal point Organization:

    Mechanical Science Research Institute

  • Publishing Department:

    Mechanical Science Research Institute
Introduction to standardsDescription (Translated English) / download

Skip to download

Summary:

JB/T 8027.1-1999 This standard is a revision of JB/T 8027.1-95 "Machine Tool Fixture Parts and Component Pillars". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies pillars with thread specifications of M5~M10. This standard was first issued in 1981 as GB 2233-80, first revised to GB/T 2233-91 on April 30, 1991, and adjusted to JB/T 8027.1-95 in April 1996. JB/T 8027.1-1999 Machine Tool Fixture Parts and Component Pillars JB/T8027.1-1999 Standard download decompression password: www.bzxz.net
Standard contentStandard content

Some standard content:

ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixturesSupporters
This standard specifies the support with thread specifications of M5~M10. Referenced Standards
JB/T 8027.1-1999
Replaces JB/T 8027.1—1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard was published, the versions shown were all valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest version of the following standards. GB/T6991988 Technical conditions for high-quality carbon structural steel JB/T8044—1999
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 and implemented on January 1, 2000
4 Technical conditions
Material: 45 steel in accordance with the provisions of GB/T699.
4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions in accordance with the provisions of JB/T8044. 5 MarkingbZxz.net
5.1 Marking example:
Pillar with d=M5, L=40mm:
JB/T8027.1-1999
Basic size
Pillar M5×40JB/T8027.1—1999
Limit deviation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
  • Recommended standards
Please remember: "bzxz.net" is the combination of the first letters of the Chinese pinyin of the four Chinese characters "standard download" and the international top-level domain name ".net". ©2024 Standard download websitewww.bzxz.net Mail：wymp4wang@gmail.com