GB/T 16695-1996 Symbols for bulbous bows and thrusters in shipbuilding

This standard specifies the symbols for bulbous bows and thrusters used on ship hulls. GB/T 16695-1996 Bulbous bow and thruster symbols for shipbuilding GB/T16695-1996 Standard download decompression password: www.bzxz.net

ICS 47. 020. 10
National Standard of the People's Republic of China
GB/T16695—1996
idtIS06050:1987
ShipbuildingBulbous bow and side thruster symbols1996-12-18 Issued
State Bureau of Technical SupervisionWww.bzxZ.net
1997-08-01 Implementation
CB/T16695—1996
This standard is equivalent to IS06050:1987 ShipbuildingThis standard is proposed by China State Shipbuilding Corporation. This standard is approved by the Comprehensive Technical and Economic Research Institute of China State Shipbuilding Corporation. The unit of this standard is: Comprehensive Technical and Economic Research Institute of China State Shipbuilding Corporation. The main drafter of this standard is Kang Yuan.
GB/T16695—1996
ISO Foreword
ISO (International Organization for Standardization) is an international organization of national standard bodies (ISO member groups). The formulation of international standards is carried out by ISO's technical committees. Each member group has the right to participate in the committee if it is interested in the subject of a technical committee. Governmental and non-governmental international organizations associated with ISO can also participate in this work. The draft international standards adopted by the technical committees are sent to the member groups for approval before being approved as international standards by the ISO Council. According to the ISO standard formulation procedure, the international standard draft must be voted in favor by at least 75% of the members to become an international standard. International standard ISO6050 was prepared by ISO/TC8…-Shipbuilding and Marine E-structures Technical Committee. Users should note that all international standards are subject to frequent revision. Unless otherwise specified, all other international standards cited in this standard refer to the latest versions. 1 Scope National Standards of the People's Republic of China Ballooning and Side Thruster Symbols Shipbuilding-Baboas Bew and Side Thruster Synbpls This standard specifies the symbols for bulbous nose ballast and side thruster used on the hull. 2 General provisions 2.1 Symbols and dimensions 2.1.1 The symbols and their minimum dimensions shall be as shown in Figures 1 and 2. 2.1.2 When using larger symbols, the size ratios shown in Figures 1 and 2 shall be maintained. 2.2 Width GB/T16695--1996 Idt ISO 6050:1987 2.2.1 The bulbous nose symbol shall be clearly visible above the maximum waterline of the left and right front ends of the vessel and shall point in the bow direction. 2.2.2 The thruster symbol shall be above the maximum waterline of the left and right front ends and shall be located as far as possible on a vertical line that avoids the thruster position. 2.3 The rotation line of the color symbol shall be black and shall be colored in a color that is in contrast to the ship's light. Figure 1 Bulbous nose symbol Approved by the State Administration of Technical Supervision on December 1, 1996 National thruster number Unit: mm Implementation on August 1, 1997
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.