INdex
GB standard
Standard category
Machinery Industry
It standard
Industry Standard
Chemical Industry It standard Petrochemical ZB Industry Light industry Railway industry Shipping industry Measurement standards

JB/T 8010.17-1999 Self-adjusting clamping plate for machine tool fixture parts and components

time: 1999-08-06 15:00:00
  • JB/T 8010.17-1999
  • in force

Basic Information

standard classification number

  • Standard ICS number:

    General, Terminology, Standardization, Documentation>>Vocabulary>>01.040.29 Electrical Engineering (Vocabulary)

  • China Standard Classification Number:

    Machinery>>Process Equipment>>J44 General Fixture

associated standards

Publication information

Other Information

  • Focal point Organization:

    Mechanical Science Research Institute

  • Publishing Department:

    Mechanical Science Research Institute
Introduction to standardsDescription (Translated English) / download

Skip to download

Summary:

JB/T 8010.17-1999 This standard specifies self-adjusting clamps with an adjustment range of 0~200mm. This standard was first published in 1983 as JB 3408-83 and revised for the first time in 1991 as GB/T 12872-91. JB/T 8010.17-1999 Self-adjusting clamps for machine tool fixture parts and components JB/T8010.17-1999 Standard download decompression password: www.bzxz.net
Standard contentStandard content

Some standard content:

ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and units of jigs and fixtures
Self-regulating pressure plate
The parts and units of jigs and fixturesSelf-regulating pressure plate This standard specifies the self-regulating pressure plate with an adjustment range of 0~200mm. 2
Cited Standards
JB/T8010.17-1999
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard was published, the versions shown were valid. All standards are subject to revision, and parties using this standard should explore the possibility of using the latest version of the following standards. GB/T898—1988
JB/T 8004.1—1999
JB/T8004.11—1999
3 Dimensions
Dimensions are shown in the following figure and table.
4 Marking
4.1 Marking example:
Stud b=1.25d
Machine tool fixture parts and components Shouldered hexagonal nut Machine tool fixture parts and components T-slot nut Adjustment range of 0~70mm Self-adjusting pressure plate: Pressure plate 0~70JB/T8010.17—1999
Approved by the State Machinery Industry Bureau on 1999-08-06 and implemented on 2000-01-01bZxz.net
Adjustment range
0 ~200
JB/T 8004.
JB/T8010.171999
Note: The length of the double-headed stud can be selected according to its adjustment range, according to GB/T898 115
JB/T 8004.1
GB/T898
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
  • Recommended standards
Please remember: "bzxz.net" is the combination of the first letters of the Chinese pinyin of the four Chinese characters "standard download" and the international top-level domain name ".net". ©2024 Standard download websitewww.bzxz.net Mail：wymp4wang@gmail.com