Preparation of outline drawings of camera tubes

SJ/T 10407-1993 Drawing of the camera tube outline SJ/T10407-1993 standard download decompression password: www.bzxz.net

Electronic Industry Standard of the People's Republic of China
SJ/T 10407--93
Preparation of outline drawings of tamera Lules1993-12-17Promulgated
1994-06-01Implementation
Ministry of Electronics Industry of the People's Republic of China
Electronic Industry Standard of the People's Republic of China
Drawing of outline drawings of tamera Lules
['r:paration nf uiline crawngsnf camera lubes
Subject content and use
This standard specifies the overall design of outline drawings of slow-acting electronic devices. This standard is used to provide the final reference standard of outline drawings of image tubes.
G ?H7 The tube base
3 is the outer dimensions of the image tube. The outer dimensions of the image tube are shown in the table,
S71 1C48793
If the dimensions listed in the table are not in accordance with the given system: then these dimensions should be given in the outer dimensions. The nominal table and
tube have no external manufacturing
registered maximum outer diameter
rain plate diameter
technical external large surface user ring distance
signal quality
high lead length
line card\
situation according to the line length
bao: 1) high lead wire is packaged 1
2 also line color 1
3: signal board lead wire is white:
nominal!
4) Based on G787, see the timing recovery (allowed to draw and note the size 4 camera general appearance drawing example
1993·12t7 approval of the Ministry of Electronics Industry of the People's Republic of China
1954-DE-7 implementation
The figure is the appearance of the video tube.
SL/T 10407-93
Figure 3 is the shape of the unexcited belt transfer tube. Figure 3 is the appearance of the light-weight video tube with transfer. The codes in the figure refer to the codes in the appearance dimension table, Figure
A1 range
Sr./T 10407—93
Appendix A
Drawing of the base diagram of the image sensor tube
(Supplement)
When the base of the image sensor tube does not comply with the provisions of GB787, the tube grid shall be drawn according to this appendix. A2 The base of the tube shall only comply with the table
The tube tea size table is shown in Table A1
Black ruler
White dragon measurement of large height diameter
General center city reading diameter
Needle measurement and diameter
Exhaust diameter
Quality coordinationwww.bzxz.net
Neighboring Tube-phase body tube base center angle
A3 recording tube base drawing example
Tube base drawing example is shown in Figure A1.
The code in the figure must be the code in Table A1
Additional explanation:
This standard is under the jurisdiction of the Standardization Research Institute of the Ministry of Electronics Industry. This standard is jointly developed by the 15th Institute of the Ministry of Electronics Industry and the Standardization Research Institute. The main drafters of this standard are Song Shengliang, Hu Tijian and Fu Meizhi. Standard
The most important
The most important
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.