JB/T 9163.16-1999 Intermediate sleeve dimensions

JB/T 9163.16-1999 JB/T 9163.16-1999 Intermediate sleeve dimensions JB/T9163.16-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
JB/T9163.1~9163.20--1999
Fixtures and attachments for gear cutting machine
Fixtures and attachments for gear cutting machine1999-05-20Promulgated
State Administration of Machinery Industry
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Intermediate sleevebzxz.net
Dimensions
Bushs for changbg dinteler
-Dimcnsiuns
JB/T9163.16—1999
1: 2± 152 e92.16 - 8:
This standard specifies the type and size of the middle length, which is suitable for ten gear hobbing, gear grinding tools and shafts, with a positioning diameter of 30mm2. Type and size
The type and size can be specified in the following figure and table. 1. ≤ S0 mm
L>50mm
Guohao Machinery Shangye Shield 999-05-20 approved
2000-01-01 implemented
Total limit case h6
JB/T 9163.16-1999
Complete installation stop light
Limited cancer production
JBT9163.16—1999
Table (continued)
Basic upgrade
3 mark
Special example:
Limit low blue h6
JBT9163.16-19
0=36mm, 2-30mm intermediate set mark 365016316999
Guaranteed according to the report!
-9163.16—1999
Appendix A
(Note!
The outer diameter of the intermediate sleeve with process specifications
The outer diameter of the intermediate sleeve listed in this appendix is ​​an arbitrary value, which is determined by the processing specifications in the order of the bamboo certificate. Please use the outer diameter price
.56.30
The maximum photo h6
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.