JB/T 8027.2-1999 Universal support for machine tool fixture parts and components

JB/T 8027.2-1999 This standard is a revision of JB/T 8027.2-95 "Universal supports for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies universal supports with specifications of 10~36mm. This standard was first issued in 1981 as GB 2239-80, first revised to GB/T 2239-91 on April 30, 1991, and adjusted to JB/T 8027.2-95 in April 1996. JB/T 8027.2-1999 Universal supports for machine tool fixture parts and components JB/T8027.2-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
Uniuersal supporters
This standard specifies the universal support with specifications of 10~36mm. 2 Dimensions
The dimensions are shown in the following figure and table.
T-shaped width.
3.1 Marking example
a-10mm, h=8mm, H=13mm universal support; universal support 10×8×13JB/T8027.2—1999Approved by the State Machinery Industry Bureau on 1999-08-0618bzxz.net
JB/T8027.2—1999
Implemented on 2000-01-01
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.