JB/T 9980-1999 Inertia vibrating table types and basic parameters

JB/T 9980-1999 This standard is a revision of ZB J61 003-88 "Inertia vibrating table types and basic parameters". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the types and basic parameters of inertia vibrating tables. This standard is applicable to inertia vibrating tables for compacting resin self-hardening sand molds (cores) in foundries. This standard was first issued in February 1988. JB/T 9980-1999 Inertia vibrating table types and basic parameters JB/T9980-1999 standard download decompression password: www.bzxz.net

IGS 77.180
Machinery Industry Standard of the People's Republic of China
JB/T9980-1999
Inertial Vibrating Table
1999-05-14 Issue
Type and Basic Parameters
200-01 Implementation
National Bureau of Machinery Industry
JB.T998D-1999
This standard is a revision of ZBJ6103-88 "Inertial Vibrating Table Type and Basic Parameters". Only the relevant provisions have been revised, and the technical content has not changed. This standard replaces ZBJ61003-88 from the date of implementation. The standard is drafted and approved by the National Foundry Machinery Standardization Technical Conference. The responsible drafting unit of this standard is: Jinan Foundry Hip Pressure Vibrating Recovery Research Institute. This standard was first issued in February 19.
Machinery Industry Standard of the People's Republic of China
Inertia Vibrating Table
Types and Basic Parameters
This standard defines the types and basic technical parameters of inertia vibrating tables. This standard applies to inertia vibrating tables used in manufacturing workshops to compact resin-hardened sand molds (cores). Types
There are two types of inertia vibrating tables: one-point frame type (see Figure 1)
straight-center fixed type
strip-feed type (see Figure 2)
3 basic integers
3.1 The main plug number is the rated load, in kN. The rated load refers to the load of the workbench. Total weight of process equipment and molding sand, 3.2 Basic sensitivity should comply with the provisions of Table 1,
National Machinery Industry Exhibition 1999-05-14 approved JB.T9980-1999 bzxZ.net
Generation 26100388
2000-01-01 implementation
Name of the performance
Determined load
Table size
Table and lifting height
Maximum basis, force
Synchronous transfer
tiraia
1500 or 3000
316.[0×2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.