JB/T 8010.3-1999 Machine tool fixture parts and components Mobile bending plate

JB/T 8010.3-1999 JB/T 8010.3-1999 Machine tool fixture parts and components Mobile bending plate JB/T8010.3-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Published
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Parts and units of jigs and fixturesMoving bend elampplate
This standard specifies the moving bend elampplate with thread specifications of M6~M42. 2 Reference standards
JB/T8010.3—1999
Replaces JB/T8010.3-1995
The provisions contained in the following standards are referenced in this standard and constitute the provisions of this standard. When this standard is published, the versions shown are valid. All standards are subject to revision, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T 699—1988
Technical conditions for high-quality carbon structural steel
JB/T 80441999
3 Dimensions
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
Approved by the State Bureau of Machinery Industry on August 6, 1999, implemented on January 1, 2000wwW.bzxz.Net
Nominal diameter
(thread diameter)
4 Technical conditions
4.1 Material: 45 steel in accordance with GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions in accordance with JB/T8044. 5 Marking
5.1 Marking example:
JB/T8010.3-1999
Mobile bending plate with nominal diameter -8mm, L-80mm: plate 8×80JB/T8010.3-1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.