JB/T 3411.95-1999 Dimensions of reducer rods

JB/T 3411.95-1999 This standard is a revision of JB 3506-83 "Dimensions of Reducer Rods". Only the following points have been modified during the revision, and the main technical content has not changed: - Writing format; - Standard name plus English; - Relevant reference standards and related content; - Thread drawing method. This standard specifies the type and size of reducer rods. JB/T 3411.95-1999 Dimensions of Reducer Rods JB/T3411.95-1999 Standard download decompression password: www.bzxz.net

1CS 25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T3411.83-3411.100-19
Accessories of boring machines
Accessories of boring machines1999-05-20 Issued
State Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Dimensions of Reducing Rods
C.hanging diuneler estension'rod-Dimtasions
The small standard specifies the type and size of reducing rods: 2. Type and size
The type and size shall be as specified in the following figure and table.
National Machinery Industry Week 1999-05-20 approved 34
JB/T 3411.95-1999
Eight Notice 3B3506-63
2HU-01-I implementationWww.bzxZ.net
3 marking
Light support part
Marking example:
T/T3411.95-1999
=45mm, the diameter of the support part is 32mm, the change-over rod: reducer rod 45×32JB/T3411.95-199911
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.