HG/T 2442-2001 Washing machine V-belt

HG/T 2442-2001 Washing Machine V-Belt HG/T2442-2001 Standard Download Decompression Password: www.bzxz.net

HG/T2442--2001bzxz.net
This standard is a revision of the chemical industry standard HG/T2442-1993 "Washing Machine V-Belt". The main technical differences between this standard and HG/T2442-1993: the flexural performance is removed.
- The requirements for all dimensional deviations of washing machine V-belts are stricter than those of HG/T2442-1993. - The dynamic performance requirements for the cord adhesion strength test and the fatigue life test on a dedicated fatigue testing machine are added. This standard replaces HG/T2442-1993 from the date of implementation. This standard was proposed by the Policy and Regulations Department of the former State Administration of Petroleum and Chemical Industry. This standard is under the jurisdiction of the chemical industry tape standardization technical centralized unit. The drafting units of this standard: Hebei Huanyu Rubber Factory, Qingdao Rubber Industry Research Institute. The main drafters of this standard: Wang Huamin, Gao Fengxian, Han Deshen, Xin Yonglu. 339
Chemical Industry Standard of the People's Republic of China
V-belt for clothes washing machine
V-belt for clothes washing machineHG/T2442—2001
Replaces HG/T2442-1993
This standard specifies the product classification, requirements, test methods, marking, packaging, storage and transportation of V-belts for clothes washing machine (hereinafter referred to as washing V-belts).
This standard applies to V-belts used for washing machine transmission. 2 Referenced Standards
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and the parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T3686--1998 Test method for tensile strength and elongation of V-belts GB/T3688-1998 Test method for adhesion strength of V-belt cords GB/T11544-1997 Dimensions of ordinary V-belts and narrow V-belts (eqvISO4184:1992) GB/T15328--1994 Test method for fatigue of ordinary V-belts No torque method 3 Classification
3.1 Structure
The belt is composed of wrapping cloth, top glue, wire and bottom glue, as shown in Figure 1.
3.2 Model
According to the cross-sectional size, the V-belt is divided into four types: M, Z, SPZ and A. 3.3 Marking
Marking example:
Approved by the State Economic and Trade Commission on January 24, 2002 340
HG/T 2442
·Base glue
-Standard No.
Antistatic marking
Reference length (mm)
Implemented from July 1, 2002
4 Dimensions
4.1 Sectional dimensions
The section dimensions of washable V-belts are shown in Table 1 and Figure 2.
Top width 6/mm
Height h/mm
Wedge angle α
4.2 Reference length
10.0±0.3
40°±1°
HG/T 2442—2001
10.0±0.3
40°±1°
The limit deviation of the reference length of the V-belt for washing shall comply with the provisions of Table 2. Table 2
Reference length (L)/mm
L≤600
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.