GB/T 14910-1994 Technical requirements for thick-walled multi-layer bearing backings for sliding bearings

This standard specifies the technical requirements for thick-walled multi-layered sliding bearing backings. Its purpose is to ensure good adhesion between the sliding bearing alloy and the bearing backing. This standard applies to thick-walled bearings where the sliding bearing alloy is cast on the bearing backing or the bearing seat hole. GB/T 14910-1994 Technical requirements for thick-walled multi-layered sliding bearing backings GB/T14910-1994 standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Plain bearings-Technical requirements on backings forthick-walled multilayer bearingsGB/T14910-94
This standard adopts the international standard ISO62801981 "Plain bearings-Technical requirements on backings forthick-walled multilayer bearings". 1 Subject content and scope of application
This standard specifies the technical requirements for thick-walled multilayer plain bearing backings. Its purpose is to ensure good adhesion between the plain bearing alloy and the bearing backing.
This standard applies to thick-walled bearings in which the plain bearing alloy is cast on the bearing backing or the bearing seat hole. 2 Reference standards
GB699 Technical conditions for high-quality carbon structural steel
GB1176 Technical conditions for cast copper alloyswwW.bzxz.Net
GB9439 Grey cast iron parts
Cast carbon steel parts for general engineering
GB11352
3 Bearing backing materials
The materials used for thick-walled multi-layer sliding bearing backing are generally steel, cast steel, cast iron, and cast copper alloy. 3.1 Steel and cast steel
In order to facilitate the bonding of bearing alloy and steel backing, the bearing backing needs to be heat treated to eliminate internal stress before casting the bearing alloy. The steel backing material should be 10, 15, 20, 25 steel specified in GB699. The cast steel backing material should be ZG 200-400 specified in GB11352.
3.2 Cast iron
Cast iron backing materials should generally be HT250 or other grades of cast iron specified in GB9439, but the ferrite structure or coarse ferrite structure content should be greater than 85%. Its chemical composition is: Si<2.5%
C≤3.35%
3.3 Cast copper
Cast copper backing materials - generally should be ZCuSn5Pb5Zn5 or ZCuSn10Pb1 specified in GB1176.4 Requirements for the inner surface of the bearing back before the bearing alloy is cast 4.1 The inner surface roughness of the bearing back before the bearing alloy is cast R. =3.2~6.3μm. 4.2 Before casting the bearing alloy, there should be no oil stains and oxide scale on the inner surface of the bearing back. Approved by the State Bureau of Technical Supervision on February 21, 1994368
Implemented on October 1, 1994
Additional Notes:
GB/T14910—94
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China. This standard is under the jurisdiction of the Machinery Standardization Research Institute of the Ministry of Machinery Industry. This standard was drafted by the Machinery Standardization Research Institute of the Ministry of Machinery Industry and Shanghai Bearing Factory. The main drafters of this standard are Wan Ma and Liu Jilun. 369
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.