GB/T 3668.5-1983 Dimensions of power boxes for common components of modular machine tools

GB/T 3668.5-1983 Dimensions of power boxes for common components of modular machine tools GB/T3668.5-1983 Standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Common Components for Modular Machine Tools
Power Box Dimensions
Modular units for machine tool constructionlonHeadstocks --Dtmenstons
This standard is equivalent to ISO2727-1973 "Common Components for Modular Machine Tools-1 Scope
This standard specifies the relevant interchangeability dimensions of power boxes for modular machine tools. 2 Nominal dimensions and names
The nominal dimensions are specified in terms of the saddle width of the corresponding slide. The following nine nominal dimensions are used: 1
125, 160, 200, 250, 320, 400, 500, 630 and 800mm. The names are specified in terms of nominal dimensions.
3 Description
-Power box".
The dimensions of the power box with a nominal size of 125~250mm shall comply with the provisions of Figure 1 and Table 1. 8.1
The end face transmission key or shaft and flat key transmission can be adopted. 3.2 The dimensions of the power box with a nominal size of 320~800mm shall comply with the provisions of Figure 2 and Table 2. The transmission can be carried out by coupling or gear transmission, or other means. 4 Size
4.1125~250mm power box
National Bureau of Standards 1988-05-09
UDC 621.9—21
GB 3668.5—83
S0 27271973
1984 03-01 implementation
GB3668.5—83
b/2±price,01
Base cone surface
Figure 1: 125~250mm power box
Note: () S=25mm or an integer multiple of 25mm. ②Two positioning methods are allowed: using a boss and a pin hole, or using two pins instead of a boss 2 Table 1125~250mm power box size
Nominal size small
4.2320~800mm power box
Bolt size matching through hole a and corresponding
chain according to GB1096-79
GB3668.5--B3
:*2±0.02
Nominal size 320mm1 large holebzxz.net
coupling center
Figure 2320~800mm power box
Note: (1) S=25mm or an integer multiple of 25mm. ② When this standard is adopted equivalently, some dimensions such as drive rails, couplings and locating pin holes are added. The dimensions of multi-axis boxes and input shafts are in "
③ The axial position and connection dimensions of the couplings can be found in CB3668.1-83 "Common Parts of Modular Machine Tools Table 2
1000960
In 0, 02
320~800mm power box dimensions
Screws matching through holes
a and b
Additional notes:
GB3668.5-83
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China. This standard was drafted and managed by the Dalian Modular Machine Tool Research Institute of the Ministry of Machinery Industry. The main drafters of this standard are Cao Weiqian and Li Fu: From the date of implementation of this standard, the former Ministry of Machinery Industry standards JB1522-75 "Nominal dimensions, parameters and interchangeable dimensions of power boxes with coupling transmission of common components of modular machine tools", IB-1523-75 "Nominal dimensions, parameters and interchangeable dimensions of power boxes with gear transmission of common components of modular machine tools" and JB2507-78 "Nominal dimensions, parameters and interchangeable dimensions of power boxes with end key transmission of common components of modular machine tools" will be invalid.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.