JB/T 7055-1993 Types, main dimensions and basic parameters of booster tanks for mechanical seal systems

This standard specifies the type, main dimensions and basic parameters of booster tanks for mechanical seal systems. This standard applies to booster tanks for mechanical seal systems. JB/T 7055-1993 Type, main dimensions and basic parameters of booster tanks for mechanical seal systems JB/T7055-1993 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of Chinawww.bzxz.net
JB/T7055-93
Pressure Boosting Tank for Mechanical Seal System
Type, Main Dimensions and Basic Parameters
Published on 1993-09-23
Ministry of Machinery Industry of the People's Republic of China
Implemented on 1994-07-01
Mechanical Industry Standard of the People's Republic of China
Pressure Boosting Tank for Mechanical Seal System
Type, Main Dimensions and Basic Parameters
Subject Content and Scope of Application
This standard specifies the type, main dimensions and basic parameters of the boosting end for mechanical seal system. This standard applies to the boosting tank for mechanical seal system. Type and main dimensions
JB/T7055-93
The boosting tank is a piston and a cylinder body to achieve the boosting function. The boosting tank has two types, A and B. The main dimensions are shown in the figure. K. Room
A-sealing liquid inlet G1/2\, B-sealing outlet G1/2", C-pressure source interface G1/2\, D-cooling water inlet $15X1.5E-cooling water outlet = 15×1.5, F-supplementary interface G1/8\, G-vent hole G1/2\Approved by the Ministry of Machinery Industry on September 23, 1993
Implemented on July 1, 1994
Basic parameters
The basic parameters of the booster tank are shown in the table.
Piston ratio||t t||Effective volume
Pressure level
Using temperature
Shell volume
Heat exchange area of ​​radiator
Additional instructions:
JB/T7055-93
Basic parameters of booster protection
This standard is proposed and managed by the General Machinery Research Institute of the Ministry of Machinery Industry. This standard was drafted by the Dalian Acid Resistant Ticket Factory Mechanical Seal Branch. The main drafters of this standard are Zhang Yong and Gu Hongji6.3
60~+200
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.