JB/T 8328.1-1996 Precision of single-column vertical lathe with movable table

This standard adopts ISO 3655-1986 (E) "Precision test of single-column and double-column vertical lathes". This standard specifies the requirements and test methods for the geometric accuracy and working accuracy of single-column vertical lathes with movable table. This standard is applicable to single-column vertical lathes with movable table with a maximum turning diameter of 2500~5000mm. JB/T 8328.1-1996 Precision of single-column vertical lathes with movable table JB/T8328.1-1996 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
JB/T 8328.1-96
Single-column vertical lathe with movable table
Published on 1996-n4-11
Ministry of Machinery Industry of the People's Republic of China
Implemented on 1996-10-01
Mechanical Industry Standard of the People's Republic of China
Single-column vertical lathe with movable table
This standard refers to 1SO36551986 (E) Precision inspection of single-column and double-column vertical lathes 31 Subject content and scope of application
JD/T 8338. 1-96
Standard specifies the requirements and inspection methods for the geometrical dimensions and working characteristics of the worktable of the mobile single-column vertical lathe. The standard is applicable to the mobile single-column vertical lathe with a turning diameter of 2500~5mm. 2 Reference standards
GT11S Terms and definitions of shape and position tolerances JB2670 General rules for inspection of cutting machine tools 3 General requirements
3, 1 Refer to JH2G70 Section 1. Install the level. The level is placed on the joint block, passing through the center of the worktable, with the level placed on the level? Position, it is in the middle position of the upper worktable. The vertical and horizontal readings of the level meter are not more than 4/1000: 3.2 During the inspection, the inspection tools and inspection methods can be generally used according to the requirements of the inspection items. 3.3 During the inspection of workpiece analysis, the test piece should be inspected after fine turning. 3.4 When the actual measured length is different from the actual length specified in this standard, it can be calculated according to the provisions of Article 2.3.1.1 of JB2570. The length of the measured plate can be converted. When the converted result is less than 0.00:mm, it can still be connected to 0.0051mml:3.! When checking geometric accuracy, the workbench refers to the following: 3.6 The direction parallel to the case is the intended direction, the direction parallel to the beam is the horizontal space, 3.7 The vertical surface of the guide frame is called the horizontal plane, and the vertical surfaces perpendicular to the horizontal plane are called the transverse plane. Approved by the Ministry of Machinery Industry on April 11, 1996, and implemented on October 1, 1996, JH/T 8328.1-96, Device Holder, "JB/T 8328.1" 4 000E~0002-: 090℃ 00020001 5001/090 IH/F 8328.1-96
Shougong Committee
8328.1-96
JH/T 8328.1
Qi Shangzhuang
GOE/08Owww.bzxz.net
JB/T 8328.1-96
Ice Tip
JB/T 8328.1 96
.50 Yuan
JE/T 8328.196
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.