JB/T 9945-1999 Parameters of automatic universal saw grinding machines for woodworking

JB/T 9945-1999 This standard is a revision of the joint ZB J65 001-88 "Parameters of automatic universal saw grinding machines". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the parameters of automatic universal saw grinding machines for woodworking for grinding common tooth shapes of ordinary woodworking circular saw blades and band saw blades. This standard is applicable to automatic universal saw grinding machines for woodworking. This standard was first issued on June 12, 1988. JB/T 9945-1999 Parameters of automatic universal saw grinding machines for woodworking JB/T9945-1999 standard download decompression password: www.bzxz.net

ICS 79.120.10
Machinery Industry Standard of the People's Republic of China
JB/T9945—1999
Automatic universal saw grinder for woodworking
1999-05-14 Issued
National Bureau of Machinery IndustrybZxz.net
Implementation on 2000-01-01
3B19945—1999
This standard is a revision of 7.R165001.884 six-motion universal saw grinder. Technical changes within the specification:
This standard replaces 7FJ6500188 from the date of implementation. The standard is under the jurisdiction of Ziyang Machine Tool Research Institute, and the drafting unit is Ziyang Machine Tool Factory. The standard was first revised and issued on June 12, 1988. It was edited according to relevant regulations when it was waiting for subscription. 7
Machinery Industry Standard of the People's Republic of China
Automatic Universal Saw Grinding Machine for Woodworking
JE/T9945-1999
Original ZB165D01-88
The standard specifies the woodworking automatic universal saw grinding machine commonly used in belt saw systems for grinding ordinary woodworking blades. This standard applies to automatic universal saw grinding machines (hereinafter referred to as machine tools). The type of machine tools is shown in Table 1 (without limiting the specific structure), and the parameters should comply with the provisions of Table 1. S National Standard Machinery Industry Approved on May 14, 1999 Implementation on January 01, 2000 Dense cutting National Straight Depth Measurement Strip Quantity Large Degree Dense Head Enlarge Opening and Lowering Stroke Preparation Line Head Material Plate J8/T 9945-1999 2≥ 63
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.