GB/T 3789.31-1991 Test methods for electrical properties of transmitting tubes Test methods for synchronous pulse compression

This standard specifies the test method for synchronous pulse compression of transmitting tubes. This standard applies to transmitting tubes used in television transmitting equipment. GB/T 3789.31-1991 Test method for electrical performance of transmitting tubes Test method for synchronous pulse compression GB/T3789.31-1991 Standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Test method of electric properties of transmitting tubes
Test method of synchronizing pulse compression
Measurements of the electricel properties of trausmitting tubesMethods of measuring the press of synchronizing pluseSubject content and scope of application
This standard specifies the test method of synchronizing pulse compression of transmitting tubes. This standard applies to transmitting tubes used in television transmitting equipment. 2 Referenced standards
GB/T3789.1 Test method of electric properties of transmitting tubesGeneral provisionsGB6277 Measurement method of television transmitters
3 Terminology
Synchronizing pulse compressionpress of synchranizing pluseGB/T 3789: 31—91
Synchronizing pulse compression refers to the difference between the midpoint amplitude of the synchronizing signal of the radio frequency modulated wave and the standard value, expressed as a percentage. The nominal value of the synchronizing signal amplitude of the radio frequency modulated wave is 25% of the radiation level of the synchronizing item. Test block diagram
Test block diagram is shown in Figure 1.
Test signal generator
Waveform monitor
State Administration of Technology Supervision 1991-0 8-15 Approved Actuator
Tested tube amplifier
Synchronous pulse compression test block diagram
Test load
Shooting question or network
Monitor
1992-04-01 Implementation
Test equipment and test rules
GB/T3789.31-91
Test equipment and test rules should comply with the provisions of GB/T 3789.1 and Chapter 4 of GB6277. 6 Test steps
6.1 Apply voltage to each pole according to the specification.
6.2 Test signal generator Test signal K (u=0mV, 700mV) as shown in Figure 2. my
12μs-
Figure 2 Test signal (flat field signal)
6.3 Adjust the amplifier of the tube under test to the specified working state (the synchronization top power reaches the specified value). 6.4 Read the peak-to-peak value of the RF voltage at the synchronization level and the anti-gap level displayed on the oscilloscope screen respectively (as shown in Figure 3). Figure 3
Data processing
Use the data obtained in Article 6.4 to calculate the synchronization pulse compression value according to formula (1): Synchronization pulse compression = "1
Where: A-
-peak value of RF voltage at synchronization level, V: (AB)
1×100%
GB/T 3789.31-91
-peak value of RF voltage at blanking level, V. Note: Synchronization pulse compression is calculated according to the minimum value of (A-H) in each measurement. When A-B>0.25 A, the maximum value of (A-B) should be taken for calculation. Additional remarks bZxz.net
This standard is proposed by the Ministry of Machinery and Electronics Industry of the People's Republic of China. This standard was drafted by the Electronic Standardization Research Institute of the Ministry of Machinery and Electronics Industry.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.