JB/T 5177-1991 Rust prevention methods for tractors

This standard specifies the rust prevention method for tractors. This standard applies to the rust prevention of tractors during storage and transportation, but not to the rust prevention during the processing of parts. JB/T 5177-1991 Rust prevention method for tractors JB/T5177-1991 Standard download decompression password: www.bzxz.net

Machinery Industry Standard of the People's Republic of China
JB/T 5177-1991
Rust Prevention Method for Tractors
Published on May 18, 1991
Implementation by the Ministry of Machinery and Electronics Industry of the People's Republic of China on January 1, 1992
Mechanical Industry Standard of the People's Republic of China
Rust Prevention Method for Tractors
1 Subject Content and Scope of Application
This standard specifies the rust prevention method for tractors. JB/T5177-1991
This standard applies to the rust prevention of tractors during storage and transportation after leaving the factory, and does not apply to the rust prevention process during the processing of parts. Reference standards
JB4050
3 Rust prevention methods
Technical conditions for tractor painting
Performance indicators of vapor phase antirust oil
3.1 The paint protection of all exposed parts of the tractor shall be carried out in accordance with the classification regulations of NJ226; galvanized or chrome-plated parts shall be lubricated in accordance with the relevant requirements of the product technical conditions.
3.2 Each lubrication point of the tractor shall be lubricated in accordance with the relevant requirements of the product technical conditions. 3.3 Inject vapor phase antirust oil that meets the requirements of JB4050 into the following boxes of the tractor. The filling amount shall be carried out in accordance with the provisions of the vapor phase oil product manual.
a. Crankcase:
b, gearbox, rear axle, final drive;
c. Hydraulic system (including hydraulic brakes); d. Front drive axle;
e. Steering gear, etc.
3.4 ​​After filling with vapor phase antirust oil, start the engine and keep it in a low speed state. a. Operate the lifter, brake, and steering gear; b. Operate the forward and reverse gears of the transmission;
c. Engage and disengage the power output shaft; www.bzxz.net
d. For tractors equipped with a front drive axle, engage the front drive axle. Repeat the above operations three times. The oil temperature of the transmission and crankcase should not exceed 65°C. 3.5 Cover the transmission vents and front drive axle vents with plastic film and tie them tightly with fine wire. 3.6 For tractors equipped with auxiliary lifting cylinders and steering cylinders, apply vapor phase anti-rust oil to the piston rod of the cylinder, cover the piston rod with a plastic sleeve, and tie it tightly with fine wire.
3.7 Drain the fuel in the fuel tank, inject vapor phase anti-rust oil, cover the filter cover, and cover it with plastic film and tie it tightly. The amount of vapor phase anti-rust oil to be added shall be carried out according to the specifications of its product manual.
3.8 Cover the chrome-plated or galvanized parts with plastic film and tie them tightly with fine wire. 3.9 Exposed oxidized (blue or black) parts, chrome-plated or galvanized parts should be painted with hard film anti-rust oil. Approved by the Ministry of Machinery and Electronics Industry on May 18, 1991 and implemented on January 1, 1992
JB/T5177-1991
Non-oil chambers (such as the inner chamber of the dry clutch housing and the inner chamber of the air storage cylinder of the air brake system, etc.) can be placed with gas phase corrosion inhibitors (tablets or pills, and the vents on the clutch housing should be sealed with plastic film. The amount of corrosion inhibitor should be no less than 30g per cubic meter of cavity space. Additional notes:
This standard was proposed and managed by the Luoyang Tractor Research Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by the Luoyang Tractor Research Institute. The main drafter of this standard was Zhao Aiqin.
People's Republic of China
Mechanical Industry Standards
Rust Prevention Methods for Tractors
JB/T 51771991
Published by the China Academy of Mechanical Science
Printed by the China Academy of Mechanical Science
(No. 2, Shouti South Road, Beijing
Postal Code: 100044)
1/16 Printing Sheet 3/8
Format 880×1230
Word Count 4,000
First Edition in September 1991
First Printing in September 1991
Print Quantity 1-500
Price 0.60 Yuan
Mechanical Industry Standard Service Network: http://www.JB.ac.cn1661_IS /F
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.