JB/T 9880-1999 Diamond dressing roller installation shaft diameter

JB/T 9880-1999 This standard is a revision of ZB J52 003-88 "Diamond Dressing Roller Mounting Shaft Diameter". The main differences are: - Added two specifications 12 and 52 in Table 1; - Re-edited according to relevant regulations. This standard specifies the shaft diameter of the grinding wheel dresser for mounting diamond dressing wheels and its technical requirements. This standard applies to the mounting shaft diameter of diamond rollers. This standard was first issued in January 1988. JB/T 9880-1999 Diamond Dressing Roller Mounting Shaft Diameter JB/T9880-1999 Standard download decompression password: www.bzxz.net

1C$ 25.060.20
Machinery Industry Standard of the People's Republic of China
JB/T 9880-1999
Diamond Dressing Roller
1999-05-20 Release
National Machinery Industry Bureau
Installation Shaft Diameter
2000-01-01 Implementation
.JB/T9880-1999
This standard is a revision of 7.BJ52003-88 "Installation Shaft Diameter of Diamond Dressing Roller". The original version was formulated on the basis of analyzing the relevant data of diamond roller dressers at home and abroad, and through experimental research, combined with the characteristics of the product. Its technical depth can still meet the current scientific and technological level and meet the needs of production and use. This standard has basically the same technical contents as ZBJ52003-88, the main difference is that two specifications 12 and 52 are added in 1.
It has been revised according to relevant regulations and will replace ZBJ5213-B since its implementation. It is proposed by the National Metal Cutting Machine Tool Standardization Technical Committee and is affiliated to the National Metal Cutting Machine Tool Standardization Technical Committee. The responsible unit for this standard is Beijing Machine Tool Research Institute. This standard was first issued in January 1988. 1 Scope
Machinery Industry Standard of the People's Republic of China
Diamond Dressing Roller
Installation Shaft Diameter
JB/T9880-t999
ZBJ52003-88
This standard specifies the shaft diameter and technical requirements for the installation of diamond dressing rollers (hereinafter referred to as diamond rollers) on the wheel dressing screen. This standard applies to the installation shaft diameter of diamond filter wheels. 2 Referenced Standards
The provisions contained in the following standards shall become the text of this standard by reference in this standard. When this standard is released, the versions shown are valid. All standards are subject to revision. Parties using this standard should explore the possibility of using the latest version of the following standard: GR2R22-[981 Standard size
3 Technical requirements
3.1 The allowable values ​​of the diameter and end difference, length tolerance and roughness R of the mounting shaft shall comply with the provisions of Table 1. Table 1
Commercial accuracy line
Cylindricity
Roughness
Note: The values ​​in parentheses are not used. Deviation
Only 004
Same degree
Roughness R
Responsible button
West degree
Roughness R,bzxz.net
3.2 The long seat of the diamond roller is selected according to GB2522. For high-precision grade, at the front end of the connection with the diamond roller: a guide cone with a length of 2~5mm and a taper of 1:20 can be made. Guohao Machinery Industry Bureau approved it on May 20, 1999 and implemented it on October 1, 2000
JBrl 98801999
3.3 When the auxiliary cat of the empty diamond roller is 10mm long, a guide cone with a diameter of 1:J can be used to position the end face of the sensor. 3.4 The radial direction of the shaft and the positioning end face of the diamond roller should meet the following requirements: the commercial accuracy grade is 0.002mm; the precision grade is 0.004mm; the ordinary grade is 0.010mm2
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.