INdex
GB standard
Standard category
Machinery Industry
It standard
Industry Standard
Chemical Industry It standard Petrochemical ZB Industry Light industry Railway industry Shipping industry Measurement standards

GB/T 5278-1985 Fastener cotter pin holes and wire holes

time: 2024-08-04 19:06:02
  • GB/T 5278-1985
  • in force

Basic Information

standard classification number

  • Standard ICS number:

    Mechanical systems and general parts >> 21.060 Fasteners

  • China Standard Classification Number:

    Machinery>>General Parts>>J13 Fasteners

associated standards

  • Procurement status:

    ≡ISO 7378-83

Publication information

Other Information

  • Release date:

    1985-08-01

  • Review date:

    2004-10-14

  • Drafting Organization:

    Machinery Standards Institute

  • Focal point Organization:

    National Technical Committee for Fastener Standardization

  • Publishing Department:

    China Machinery Industry Federation

  • Competent Authority:

    China Machinery Industry Federation
Introduction to standardsDescription (Translated English) / download

Skip to download

Summary:

This standard specifies the size and location of split pins and wire holes for bolts, screws and studs. This standard is equivalent to the international standard ISO 7378-1983 "Fasteners - Bolts, screws and studs - Split pin holes and wire holes". GB/T 5278-1985 Fastener split pin holes and wire holes GB/T5278-1985 Standard download decompression password: www.bzxz.net
Standard contentStandard content

Some standard content:

National Standard of the People's Republic of China
Fasteners--Split pin holes and wireholes
Fasteners--Split pin holes and wireholesThis standard specifies the size and position of split pins and wireholes for bolts, screws and studs. UDC621.882
GB5278--85
This standard is equivalent to the international standard ISO7378-1983 "Fasteners-Bolts, Screws and Studs-Split pin holes and wireholes". 1 Split pin holes, as specified in Figure 1 and Table 1.
· Bolts, Screws and Nuts" select tolerance t. Note: According to GB3103.1--82 "Fastener Tolerances Figure 1
National Bureau of Standards 1985-08-01 Issued
1986-06-01 Implementation
Thread Specifications d
Thread Specifications d
GB5278-85
Note: For each - use occasion, the value is obtained by calculation, and after considering the cumulative tolerance of 1 and!, the distance between the hole and the end of the fastener should not be less than the value. Generally, in production, the tolerance of L, can be +IT142 metal wire hole, as specified in Figure 2 and Table 2.
Product Grade
Note: According to GB3103.1--82, the tolerance t is selected. B
Thread diameter dbzxz.net
Thread diameter d
Additional instructions:
GB527885
This standard is proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of the Standardization Research Institute of the Ministry of Machinery Industry. This standard is drafted by the Standardization Research Institute of the Ministry of Machinery Industry.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
  • Recommended standards
Please remember: "bzxz.net" is the combination of the first letters of the Chinese pinyin of the four Chinese characters "standard download" and the international top-level domain name ".net". ©2024 Standard download websitewww.bzxz.net Mail：wymp4wang@gmail.com