JG 5009-1992 Elevator operating devices, signals and accessories

This standard specifies the buttons and indicators of elevators. When handrails are installed in the car, this standard also specifies the requirements for handrails. This standard is applicable to passenger elevators, passenger and freight elevators, bed elevators and freight elevators. JG 5009-1992 Elevator operating devices, signals and accessories JG5009-1992 standard download decompression password: www.bzxz.net

Engineering Construction Standard Full Text Information System
Construction Industry Standard of the People's Republic of China JG500992
Lift-Control
devices
SignalsandadditionalfittingsConstruction Standard
1992-11-06Released
Ministry of Construction of the People's Republic of China
Engineering Construction Standard Full Text Information System
1993-05-01Implementation
.Engineering Construction Standard Full Text Information System
Construction Industry Standard of the People's Republic of China Elevator Operating Devices, Signals and Additional Fittings fittingsJG
5009-92
This standard is equivalent to the international standard ISO4190/5-1987 "Passenger elevators and service elevators-Part 5: Operating devices, signals and accessories".
Subject content and scope of application
Subject content
This standard specifies the buttons and indicator devices of elevators. When handrails are installed in the car, this standard also specifies the requirements for handrails. 1.2 Scope of application
This standard applies to passenger elevators, passenger and freight elevators, bed elevators and freight elevators. 1.2.1 The description of the control part in this standard is only to identify various buttons and indicator devices. Therefore, no complete description of various types of controls is given. Table A1 summarizes which devices are necessary and which devices are optional in the various cases described.
1.2.2 For economic reasons and to provide better service, group-controlled elevators have common operating devices and electrical connections between each other. The complexity of this system is related to the number of group-controlled elevators and the expected passenger flow. Therefore, this standard does not cover supplementary signals that the manufacturer considers useful (such as "this elevator goes first" signal). 1.2.3 This standard also does not cover the following: a. Special features (and their corresponding signals), such as certain features to improve the service of bed elevators; b. In the case of automatic doors, any device used to increase the transportation capacity (adjustable delay devices according to different requirements, door closing buttons, etc.).
Even in these special cases, the operating devices and basic signal devices specified in this standard must be followed, and this standard should also be used as a guide when expanding supplementary signals. 2
Referenced Standards
GB7025 Main Parameters of Elevators and Types and Dimensions of Cars, Hoistways and Machine RoomsGB7588 Safety Specifications for Elevator Manufacturing and InstallationApproved by the Ministry of Construction of the People's Republic of China on November 6, 1992Full Text Information System of Engineering Construction Standards
Implementation on May 1, 1993
bzSoeO,coPresent Full Text Information System of Engineering Construction StandardsbZxz.net
3 Technical Requirements
3.1 Single Button Control
3.1.1 General Provisions
Single button control is the simplest type of automatic elevator control. It only responds to the call of the landing station and can carry passengers to the destination when the car is at the station and the door is closed. A simple timing device enables passengers to register the floor selection and leave the car at their leisure. This type of control is particularly suitable for small residential elevators or freight elevators with small passenger transportation volume. 3.1.2 Operating devices
3.1.2.1/ At the landing
Each landing is equipped with an unmarked call button. 3.1.2.2 Inside the car
Each landing is equipped with a command button: marked as -2, -1, 0, 1, 2, 3...; an alarm button: yellow, marked as a bell symbol; a door opening button: for automatic doors, marked as
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.