JB/T 3411.12-1999 Dimensions of holders for tools with Morse taper shanks

JB/T 3411.12-1999 JB/T 3411.12-1999 Dimensions of holders for tools with Morse taper shanks JB/T3411.12-1999 Standard download decompression password: www.bzxz.net

ICS25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T3411.12-1999
Clamp for Morse taper shank tool
Clamp for Morse taper shank tool Dimensions1999-05-20 Issued
State Machinery Industry Bureau
2000-01-01 Implementation
1 Scope
Machinery Industry Standard of the People's Republic of China
Clamp for Morse taper shank tool
Clamp for Morse taper shank tool DimensionsThis standard specifies the type and dimensions of the clamp for Morse taper shank tool. Type and Dimensions
The type and dimensions shall be as specified in the following figure and table. l
Ji Shi Hua Gui
Type Morse taper number
C turn
Note: The dimensions and deviations of Morse taper shall comply with GBT14431985 "Dimensions and tolerances of Morse tool tapers" 3
Marking example:
Morse taper No. 1, Morse taper shank tool holder with h=16mm Holder 1-16JB/T3411.12—1999
National Machinery Industry Bureau approved JB/T3411.12—1999 on May 20, 1999
Replace JB342283
Applicable lathe models
C-800, C-1000
2000-01-01 implementation
Machinery industry standard
Morsch taper shank tool holder
JB/T3411.12-1999
Published by the Machinery Standardization Research Institute of the Ministry of Machinery Industry Printed by the Machinery Standardization Research Institute of the Ministry of Machinery Industry (No. 2 Shouti South Road, Beijing: Postal Code 100044)*
Format 880×1230
X number of characters xXX,XXX
Sheet X/X
Xth printing in XX month, 19XX
Xth edition in XX month, 19XX
Number of prints 1-XXXWww.bzxZ.net
Price XXXXX Yuan
XX-XXX
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.