JB/T 2462.9-1999 Parameters and dimensions of cross slides, common components of modular machine tools

JB/T 2462.9-1999 This standard is a revision of JB 2503-78 "Parameters and interchangeable dimensions of cross slides for common components of modular machine tools". Only editorial changes have been made according to relevant regulations, and the main technical content has not changed. This standard specifies the parameters and interchangeable dimensions of cross slides for modular machine tools. This standard is applicable to cross slides for modular machine tools and their automatic lines. This standard was first issued in 1978. JB/T 2462.9-1999 Parameters and dimensions of cross slides for common components of modular machine tools JB/T2462.9-1999 Standard download decompression password: www.bzxz.net

1C25.6.99
Machinery Industry Standard of the People's Republic of China
JB/12462.1~2462.28-1999
Common Components for Combined Machine Tools
Published on 1990-05-21
State Machinery Industry Bureau
2(MI-01-1 Implementation
. [B.T2462.9—1999
standard is a revised standard based on JR57S "Combination machine tool pressure parts cross slide, the majority of the ten thousand replacement standard" and 1R250-78 reduced technical content consistent. The instrument was revised and edited according to the relevant provisions, and this standard 2503-78 was issued by the National Standardization Committee of the National Metallurgical Cutting Machine Tool Technical Parts Committee. This standard was issued by the National Metallurgical Cutting Machine Tool Branch of the National Standardization Committee of the National Metallurgical Cutting Machine Tool Association: The responsible person for the standard is the Institute of Combined Machine Tools of the People's Republic of China. This standard was first issued in 1978,
The standard of the machinery industry of the People's Republic of China
Common parts of modular machine tools
Cross slides
Parameters and dimensions
The standard specifies the parameters and dimensions of nearly ten types of modular machine tools. This standard is applicable to modular machine tools and their soft-structure slides: 2 Reference standards
JR/T2462.9—1999
B2503—78
The provisions contained in the following standards are generally cited in this standard and constitute the contents of this standard. At the time of this standard revision, the versions shown are valid. All versions will be revised. When using this standard, the latest version of the following standards may be used. GH[58-15996] The table is divided into T-shaped stations and corresponding gland plugs 3. Each number and interchangeable size
3.11 The number of the t-shaped slide is the surface width B, which is specified as 10mm.125mm: 160mm, 200mm, 25mm. Wang type specification
3.2 The other parameters and interchangeable sizes of the "t-shaped slide" shall comply with the national! ", table " regulations. The T-shaped, the chain on the top and the bottom of the table can be open or not
T-shaped has GB/T355
: with a rectangular, degree (direction: ratio, can be described as the effect of the lower horizontal 1
National Machinery Industry Bureau approved 19-05-20 ||t t||2000-01-01Buy implementation
Uniform operation platform tabletop design
Lower room and length
1along the platform surface length
Sliding seat bottom constructionWww.bzxZ.net
Equipment platform height
Lower seat bottom width
【Shape
Sliding store bottom end wire generation center cabinet
One live seat tight after the whole
Sliding seat cumulative live oyster price hole
Slip azole screw hole distance
Lower full bed bottom plastic bolt hole center
Longitudinal area
Ground analysis
Effective stepping force
JB/T2462.9—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.