JB/T 7153.1-1993 Basic parameters of wheel bulldozers

This standard specifies the types, terms and basic parameters of wheel bulldozers. This standard applies to bulldozers with tire hydraulic mechanical transmission and fixed side-tilting bulldozers with power of 75kW or more (including 75kW). JB/T 7153.1-1993 Basic parameters of wheel bulldozers JB/T7153.1-1993 Standard download decompression password: www.bzxz.net

Mechanical Industry Standard of the People's Republic of China
JB/T7153.1-93
Wheeled bulldozer
Published on November 21, 1993
Basic parameters
Implemented on March 1, 1994
Ministry of Machinery Industry of the People's Republic of China
Mechanical Industry Standard of the People's Republic of China
Basic parameters of wheeled bulldozer
Subject content and scope of application
This standard specifies the types, terms and basic parameters of wheeled bulldozers. JB/T 7153.1—93
This standard applies to bulldozers with tire-type hydromechanical transmission and fixed side-tilting bulldozers (hereinafter referred to as bulldozers) with power of more than 75kW (including 75kW).
2 Reference Standards
GB8590 Bulldozer Terminology
3 Terminologywww.bzxz.net
3.1 Rated Engine Power
Net power output of the engine with all accessories (including fan, water tank, air filter, muffler, no-load generator and air compressor) for 12 hours continuously under standard atmospheric conditions (ambient temperature 20℃, atmospheric pressure 0.1MPa, relative humidity 60%). 3.2 Bulldozer Weight
The bulldozer weight shall comply with the provisions of Article 2.3 of GB8590. 3.3 Maximum Traction
The maximum value of the driving force from the maximum torque of the engine through the transmission system to the terminal of the walking device and limited by the ground adhesion. 3.4 Maximum Vehicle Speed
The maximum vehicle speed shall comply with the provisions of Article 4.2 of GB8590. 3.5 Bulldozer lifting height
The bulldozer lifting height shall comply with the provisions of Article 3.2.2.2 of GB8590. 3.6 Minimum turning radius
The minimum turning radius shall comply with the provisions of Article 2.2.2.15 of GB8590. 3.7 Climbing grade
The slope shall comply with the provisions of Article 4.4 of GB8590. 4 Basic parameters
The basic parameters of the bulldozer shall comply with the provisions of the following table. Approved by the Ministry of Machinery Industry on November 21, 1993
Implemented on March 1, 1994
Parameter name
Rated engine power
Machine weight
Maximum traction
Maximum vehicle speed
Bulldozer lifting speed
Bulldozer lifting height
Minimum turning radius
Ideal slope
Additional instructions:
JB/T7153.1-93
Basic parameters of wheel bulldozers
This standard is proposed and managed by the Tianjin Engineering Machinery Research Institute of the Ministry of Machinery Industry. 100
Equal to or greater than 0.75 times the weight of the whole machine
≥960
This standard is drafted by the Xining Plateau Engineering Machinery Research Institute of the Ministry of Machinery Industry. The main drafters of this standard are Feng Huisheng, Chu Xin, Zeng Zhong, Li Qing, >360
≥1200
≤8500
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.