GB/T 3911-1983 Graphical representation of control characters of the seven-bit coded character set for information processing

This standard specifies the graphic representation of control characters in GB 1988-80 "Seven-bit coded character set for information processing interchange". GB/T 3911-1983 Graphic representation of control characters in seven-bit coded character set for information processing GB/T3911-1983 Standard download decompression password: www.bzxz.net

1 Introduction
National Standard of the People's Republic of China
Graphical representations of the control characters of 7-bit coded character set for information processing UDC 681.3:003
.62/.63
GB3911-83
1s02047-1975
1.1 This standard specifies the graphical representation of the control characters of GB 1988-80 "7-bit coded character set for information processing interchange". These characters are located in columns 0 and 1 of their codes. For the space character (SP) and the erasure character (DFI) which are not usually printed and displayed, this standard also gives their graphical representations. In the code table, the space character is located at position 2, center, and the erasure character is located at position 15. 1.2 This standard represents control characters in two ways: Special symbol representation: For each control character that is not normally printed or displayed, a separate graphic representation is given.
b. Alphanumeric representation: Each control character is represented by a combination of two characters. It contains the name of the control character in GB1988.
1.3 When control characters that are not printed or displayed need to be represented in a graphic form, this standard provides their visual graphics. It is suitable for devices such as paper tape punchers, printers and displays, and can be used in various situations such as monitoring and diagnosis. 1.4 This standard does not specify the precise design of the symbol shape. 1.5 The graphic representation specified in this standard does not require every device to implement all of them. It can only implement some of the symbols according to actual needs. However, all graphic representations of control characters in GB1988 must comply with the provisions of this standard. 1.6 The alphanumeric representation of each control character should be regarded as a separate symbol. Depending on the device and its implementation method, it can occupy one or more positions in the printed or displayed line. 1.7 This standard equivalently adopts the international standard 1S02047-1975 "Information processing - seven-bit coded character set control word titles"
2 Main related standards
GB1988-80 "Seven-bit coded character set for information processing interchange". 3 indicates
Character name
National Bureau of Standards1983-11-02issued
Title andbzxz.net
Obstetric Mathematics Long Demonstration
1984 10-01implemented
Set in the code table
Ning character name
(Character symbol
GB3911-83
Beginning of text
End of text
Transmission nest
Horizontal tabulation
Vertical tabulation
Sketch, when equipment permits, you can also use Xuehai Shuying to indicate
Position in the code table
Character name
GB 3911-83
Data link escape
Equipment control 1
Equipment control 2
Equipment control 3
Equipment control 4
Alphanumeric representation
Compensation table
School name
GB3911-83
Transmission end
Media solution
Document separation
Group separation
Record separation
Single separation
School alphabetic representation
Code table 4 settings
Additional instructions:
Alphanumeric name
GB3911-83
This standard was proposed and drafted by the Standardization Research Institute of the Ministry of Electronics. Figure
School digital representation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.