JB/T 9168.10-1998 General process code for cutting machining - CNC machining

JB/T 9168.10-1998 JB/T 9168.10-1998 General process code for cutting machining CNC machining JB/T9168.10-1998 Standard download decompression password: www.bzxz.net

Ks 25.020bzxz.net
Machinery Industry Standard of the People's Republic of China
JB/T9168.1~9168.13-1998
Common process instructions for cutting1998-11·16 Issued
National Machinery Industry Standard
199812-01 Implementation
1 Scope
Machinery Industry Standard of the People's Republic of China
Common process instructions for cuttingCommon procedures for culling--Pruuessinstructipns for numerically-controlled machiningIH/T9168.10--1998
Generation J2 3C71-E9
This standard specifies the basic rules for numerical control drawing, and is suitable for numerical control (NC) machine tools and computer numerical control (CVC) machine tools (including machining centers). Authors should comply with this document and also comply with the provisions of JB/T1.1 and the corresponding 1I/1916B.2--9168.
2 Referenced standards
The following standards contain the texts, which are referenced by this standard and constitute the text of this standard. When this standard is published, the versions shown are valid and all standards are subject to revision. Parties using this standard should explore the possibility of using the following standards. JB/T $168.1-1998
J/TS168.21908
JB/T 52GR.3-199R
JB/T0168.41998
JE/T 0158.5—1158
JB/T 158. -1998
Jb/T 9168.7: 1998
JI/T 9158. 8 . 1106
General process code for sawing
General process code for cutting
General process code for cutting
General process code for sawing
General process code for cutting
General process code for cutting
JB/T 2158.9--1558
Liu Sequence General Art Period
3 Preparation before processing
3.1 The performance, processing range and speed of the gears must be described in the machine tool manual, and the machine tool and its control device must be used and the operation methods must be learned. 3.2 Check whether all switches and handles are in the correct position. 3.3 Preheat the electrical control part according to the regulations. 3.4 Start the machine tool to run it idle, check all switches, and adjust the lightness, starting and hand sensitivity, etc. 3.5 The number and programming origin of the workpiece to be processed. 4 Installation of tools and workpieces
4.1 When placing tools, pay attention to the order of use. The placement of tools must be in the order and position required. 4.2 The workpiece should be mounted firmly and carefully to avoid any interference between the tool and the workpiece or between the tool and the tool during operation. 5.1 Before the workpiece is processed, it must undergo a program change test (type of operation), track speed check, single program segment test, and workability and size test. Approved by the National Machinery Industry Bureau on November 16, 1998, 190812-0 implementation. JB/9168.JU: 1998
5.2 During the processing day, the program must be input correctly and the user must not change the program.
During the process, the operator should monitor the display device at any time. When an alarm signal is found, the machine should be stopped and the fault should be eliminated in time. The control system or computer cabinet should not be opened at will during the processing. 5.4
After the processing is completed, the processing tapes, magnetic tapes or disks should be collected and properly stored for reuse. 5.5
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.