JB/T 8428-1996 Standard test blocks for calibrating ultrasonic testing instruments for steel welds

This standard is based on ISO 2400:1972 "Comparison standard test blocks for calibration of instruments for ultrasonic testing of steel welds", and is equivalent to the international standard in terms of technical content. JB/T 8428-1996 Standard test blocks for calibration of ultrasonic testing instruments for steel welds JB/T8428-1996 Standard download decompression password: www.bzxz.net

JB/T8428—96
This standard is formulated based on ISO2400:1972 "Comparison Standard Test Blocks for Instrument Calibration for Ultrasonic Testing of Steel Welds", and is equivalent to the international standard in terms of technical content.
There are two minor changes in the editing of this standard: In view of the fact that GB6349-86 "Method for Determination of Average Metal Grain" is consistent with the Mequaid grain size assessment in ISO24001972, it is changed to GB6394-86 when cited in this standard; secondly, the surface roughness expression method is unified according to the national standard.
This standard shall be implemented from July 1, 1997. This standard is proposed and managed by the National Technical Committee for Nondestructive Testing Standardization. The drafting units of this standard: Shanghai Mechanical Engineering Society Nondestructive Testing Professional Committee, Shanghai Heavy Machinery Factory The main drafting units of this standard: Shantou Ultrasonic Instrument Research Institute. The drafters of this standard: Wang Yizhi, Wang Kaisong, Tan Daji. 403
Machinery Industry Standard of the People's Republic of China
Standard test blocks for calibrating instruments for ultrasonic testing of steel weldswww.bzxz.net
This standard specifies the characteristics of comparison test blocks for calibrating instruments for ultrasonic testing of steel welds. 2 Characteristics
2.1 Materials
JB/T8428-96
idt ISO 2400: 1972
The pot used to make this test block shall have the following characteristics: low carbon steel smelted in an open hearth or electric furnace, normalized state, grain size conforming to Grade 5 or finer specified in GB6394-86 "Method for Determination of Average Grain Size of Metals". 2.2 Dimensions
The dimensions of this test block are shown in Figure 1, and the permissible deviation of the dimensions is ±0.1mm.
Organic glass
The permissible deviation of all dimensions is ±0.1mm
Figure 1 Standard test block
Approved by the Ministry of Machinery Industry on September 3, 1996
Sold on July 1, 1997
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.