JG/T 148-2002 Steel Tube Radiator

This standard specifies the symbols and abbreviations, requirements, test methods, inspection rules, marking, packaging, transportation and storage of steel tube radiators. This standard applies to radiators that use hot water as heating coal in industrial and civil buildings. JG/T 148-2002 Steel Tube Radiator JG/T148-2002 Standard download decompression password: www.bzxz.net

People's Republic of China Construction Industry Standard JG/T148—2002
Steel Tube Radiator
Steel Tube Radiator
2002-11-09 Issued
Ministry of Construction of the People's Republic of China
2003-01-01 Implementation
JG/T148—2002
The dimensions and properties of the steel used in this standard adopt the European industry standard N10130FeF01 and the German industry standard N2394TI/2. The dimensions and properties of the steel plate adopt the national industry standard IN10130-FcPJ4, so the surface modification of the radiator adopts the national industry standard DN0, and the size limit difference of the radiator adopts the national industry standard>N470. This standard is issued by the Institute of Standards and Quotations. This standard is drafted by: China Construction Machinery Corporation Beijing Senbo Heat Exchanger Co., Ltd. This standard is drafted by: Zhang Xinming, Guo Tudian, Jiang Hongyuan, Wu Xuejun, Wang Duanniu 1 Scope
Steel tube radiator
JG/T 148--2002
This standard specifies the numbers and abbreviations, requirements, test rules, markings, packaging, transportation and storage of ordinary steel radiators (hereinafter referred to as radiators). The standard is a micro-heat absorption system for high-pressure buildings with hot water as the heat medium. The water content is not high (not less than 8 × 10) and the maximum working pressure of the device is: Ma2. The following documents are used to refer to the standard. The contents of the referenced documents and their subsequent amendments or revisions are not applicable to this standard. However, the latest version of the document produced based on this standard shall apply to the latest version of the referenced document. C318754-15C2 Slow heat sink design (/T?36.5) 3.1 Classification and naming of heat sink internal effect and external end pattern
3.1 Model of heat sink
Height in units of r
Heat dissipation of pipe
3.2 Marking example ：
a? 15:er: high pressure tube heat exchanger claw 2.30 means 304m commercial heat exchanger needs G core 3060 table
1 requirements
heat exchanger basic one and grade state then high combination table [standard table! Steel heat exchanger basic size limit deviation two
Tti2ei
Cu2wcu
at the same time:
forging limit
unit is vertical meter
single length
basic 1, limit pad
"to the original is
limit danger some||tt| |JC/T148—2002
C3u-LJ
GG3JGJ
GC3UG7
ttsjgu
Tit:4nn
::416m
Note: The small size of the tea heater is small.
Table continues!
It can be measured in the mouth,
The heat receiving parts are made of high quality and meet the requirements of the table? The current standard is 4.2
TGG2180
titnen
Micro-heating surface: sheet:
..0. 3
After the certificate
plate stem
steel pipe diffuser performance parameterswwW.bzxz.Net
heat:)
negative and negative difference
this size is small
report standard deviation
Yuan test EMP.
X:4255
tx:41c5
dared heat volume/m: liter:
Table 2 (thread)
heat loss
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.