JB/T 2462.15-1999 Dimensions of side brackets (radial type) for common components of modular machine tools

JB/T 2462.15-1999 This standard is a revision of JB 2511-78 "Nominal dimensions and interchangeable dimensions of side brackets (radiant type) for common components of modular machine tools". Only editorial modifications have been made in accordance with relevant regulations, and the main technical content has not changed. This standard specifies the interchangeable dimensions of the nominal dimensions of the side brackets (radiant type) for modular machine tools. This standard applies to the radial side brackets of modular machine tools. This standard was first issued in 1978. JB/T 2462.15-1999 Dimensions of side brackets (radiant type) for common components of modular machine tools JB/T2462.15-1999 Standard download decompression password: www.bzxz.net

1C25.6.99
Machinery Industry Standard of the People's Republic of China
JB/12462.1~2462.28-1999
Combination Machine Tool Common Parts
1990-05-21 Issued
National Machinery Industry Bureau
2(MI-01-1 Implementation
JB/T2462.15—1999
This standard is based on the nominal size and size of H2511-78 combination machine tool common parts (radiant type):
This standard is consistent with the technical specifications of JE2511
8, and the relevant regulations have been re-edited and implemented to replace B357B.
This standard will be used for all metal cutting machine tools This standard is under the jurisdiction of the Technical Committee for Standardization of Metalworking Machine Tools and the Combined Machine Tool Branch of the Technical Committee for Standardization of Combined Machine Tools. The responsible drafting unit of this standard: Da Ni Combined Machine Tool Research Institute. This standard was first issued in 1978.
Machinery Industry Standard of the People's Republic of China
Common Parts of Combined Machine Tools
Side Brackets [Radial Type]
This standard defines the nominal size and five exchange dimensions of combined machine tool brackets (insertion type! This standard is applicable to the radial branch channel 2 service dimensions of combined machines
JB.T2462.15—1999
The side branch plan takes the corresponding slide table width B as the nominal size, which is divided into 100mm, 125mm, 160mm, 200mm, and 250mm.
Interchangeable size
The interchangeable size of the bracket shall comply with the provisions of Figure 1 and Table 1 . 12
\ Floor-standing base positioning force type: use or pin positioning. 2 If the floor-standing ten-question base is multi-shaped, the cross-wing hair is made into a knot, Figure
National Machinery Industry Bureau 1999-05-20 approved +4
2008-01-01 implementation
Huadi style middle bottom
Send network diameterbZxz.net
Support Diantaiyuan.
Beijing crying bottom accepted
JB/T 2462.15—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.