JB/T 3290.1-1999 Vertical Single Spindle Mortise and Tenon Machine Parameters

JB/T 3290.1-1999 This standard is a revision of JB 3290.1-83 "Vertical Single-axis Mortise and Tenon Machine Parameters". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the parameters of vertical single-axis mortise and tenon machines. This standard is applicable to vertical single-axis mortise and tenon machines. This standard was first issued on June 20, 1983. JB/T 3290.1-1999 Vertical Single-axis Mortise and Tenon Machine Parameters JB/T3290.1-1999 Standard download decompression password: www.bzxz.net

ICS79.120.10
Machinery Industry Standard of the People's Republic of China
JB/T3290.1-1999
Vertical Single-Axis Slotting Machine Parameters
Published on 1999-05-14
National Bureau of Machinery Industry
Implemented on 2000-01-01
JB/T3290.1-1999
This standard is a revision of JB3290.183 "Vertical Single-Axis Slotting Machine Parameters". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged.
This standard replaces JB3290.1-83 from the date of implementation. This standard was proposed by the National Technical Committee for Standardization of Unprocessed Machine Tools and Cutting Tools. This standard is under the jurisdiction of Fuzhou Woodworking Machine Tool Research Institute. The responsible drafting unit of this standard: Shanghai Woodworking Machinery Factory. The main drafters of this standard are Lin Chongguang, Han Wenyuan and Zheng Zongjian. This standard was first issued in June 1983. bzxz.net
Machinery Industry Standard of the People's Republic of China
Vertical Single-axis Slotting Machine
This standard specifies the parameters of vertical single-axis sample slotting machines. This standard applies to vertical single-axis sample slotting machines. Parameters
JB/T3290.1-1999
Replaces JB3290.183
The type of vertical single-axis sample slotting machine is shown in Figure 1 (without limiting the specific structure), and the parameters should comply with the provisions of Table 1. Figure
Parameter name
Maximum groove width
Maximum groove depth
Maximum width of workpiece mm
Maximum thickness of workpiece mm
Spindle speed
1) Should not be used for new design
Approved by the State Machinery Industry Bureau on 1999-05-14 12
≥2800
≥2800
Implemented on 2000-01-01
Mechanical industry standard
Vertical single-axis slot machine parameters
JB/T3 2901-1999
Published by the Machinery Standardization Research Institute of the Ministry of Machinery Industry Printed by the Machinery Standardization Research Institute of the Ministry of Machinery Industry (No. 2 Shouti South Road, Beijing: Postal Code 100044)*
Format 880×1230
X Number of characters xXX,XXX
Printing sheet X/X
Xth printing in XX month of 19XX
Xth edition in XX month of 19XX
Number of prints 1-XXX
Price XXXXX Yuan
XX-XXX
666106
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.