JB/T 8018.2-1999 Machine tool fixture parts and components fixed V-blocks

JB/T 8018.2-1999 JB/T 8018.2-1999 Machine tool fixture parts and components fixed V-block JB/T8018.2-1999 Standard download decompression password: www.bzxz.net

IC5 28.060.41
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06Promulgated
State Machinery Industry Bureau
Implementation on 2000-01-01
Mechanical Industry Standard of the People's Republic of China
Parts and components of jigs and fixtures
Fixwu v-blwek
Fixed V-block in standard title 9~
2Referenced standards
JR/T 8018.2—1999
JB812—1
5The text of the standard shall be the provisions of this standard when cited in non-standard content. When this standard is published: the version shown is valid. All standards will be revised. Parties using water standards should choose to use the latest version of the following standards if possible. GBT699-1988 Technical conditions for high-quality carbon structural steel JB/T8044..-1999 Technical requirements for machine fixture parts 3 Dimensions
The dimensions are shown in the following figure and table,
Approved by the State Machinery Industry Bureau on September 6, 1999Www.bzxZ.net
Implementation on January 1, 2000
>10 -15
>15 20
>2 - 25
>25-35
>35 - 45
>45 ~ 60
>ri -
JB/T8018.2—1959
Note: calculation: --0.7-0.5
4 Technical parts
4.1) Material: 20 according to (iR/T699 heat setting, 15
4.2 Heat treatment: filter carbon depth 0.8~1.2mm.58~64IIRC, 4.3 Other reduction conditions according to the provisions of JB/T8044, 5 mark
51 mark Example:
=18m A-type fixed V-shaped block:
Shaped A18JB/T8018.2:1999
General limited coupons
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.