clause-g15 clause-g15 下载 - 国外标准

clause-g15PDF 第 1 页 · 原页码 1

References

For the purposes of New Zealand Building Code compliance, acceptable reference documents include only the quoted edition and specific amendments as listed below.

Amend 1 Sep 1993

Standards New Zealand	Where quoted
NZS 3114: 1987 Specification for concrete surface finishes Amend: 1	AS1 3.0.2
NZS 4304: 1990 Health care waste management	AS1 3.1.1

6

1

clause-g15PDF 第 2 页 · 原页码 2

Status of Compliance Documents

Compliance Documents are prepared by the Department of Building and Housing in accordance with section 22 of the Building Act 2004. A Compliance Document is for use in establishing compliance with the New Zealand Building Code.

A person who complies with a Compliance Document will be treated as having complied with the provisions of the Building Code to which the Compliance Document relates. However, a Compliance Document is only one method of complying with the Building Code. There may be alternative ways to comply.

Users should make themselves familiar with the preface to the New Zealand Building Code Handbook, which describes the status of Compliance Documents and explains alternative methods of achieving compliance.

Defined words (italicised in the text) and classified uses are explained in Clauses A1 of the Building Code and in the Definitions at the start of this Compliance Document.

G15: Document History
	Date	Alterations
First published	July 1992
Amendment 1	September 1993	p. vi, References
Amendment 2	1 July 2001	p. 2, Document History, Status p. 4, Definitions
Note: Page numbers relate to the document at the time of Amendment and may not match page numbers in current document.

Document Status

The most recent version of this document, as detailed in the Document History, is approved by the Chief Executive of the Department of Building and Housing. It is effective from 1 July 2001 and supersedes all previous versions of this document.

People using this Compliance Document should check for amendments on a regular basis. The Department of Building and Housing may amend any part of any Compliance Document at any time. Up-to-date versions of Compliance Documents are available from www.dbh.govt.nz

2

clause-g15PDF 第 3 页 · 原页码 3

New Zealand Building Code Clause G15 Solid Waste

This Clause has been extracted from the New Zealand Building Code contained in the First Schedule of the Building Regulations 1992.

FIRST SCHEDULE–continued

Clause G15–SOLID WASTE

Provisions

OBJECTIVE

G15.1 The objective of this provision is to safeguard people from injury or illness caused by infection or contamination from solid waste.

FUNCTIONAL REQUIREMENT

G15.2 Buildings shall be provided with space and facilities for the collection, and safe hygienic holding prior to disposal, of solid waste arising from the intended use of the buildings.

PERFORMANCE

G15.3.1 Where provision is made within buildings for the collection and temporary holding of solid waste, the spaces provided shall be:

(a) Of sufficient size for the volume of waste and frequency of disposal,

(b) Provided with reasonable access for the depositing and collection of the waste,

(c) Capable of maintaining sanitary conditions having regard to the types of waste and storage containers, and

(d) Capable of maintaining the appropriate temperature for the type of waste stored.

G15.3.2 Where a rubbish chute is provided, it shall be located and constructed to:

(a) Convey the solid waste to an appropriate storage container,

(b) Avoid the likelihood of blockage or leakage,

(c) Permit easy cleaning and maintenance,

Limits on application

Requirement G15.2 shall not apply to Detached Dwellings, household units of Multi-unit Dwellings, Outbuildings or Ancillary buildings if there is independent access or private open space at ground level.

3

clause-g15PDF 第 4 页 · 原页码 4

FIRST SCHEDULE–continued

Provisions	Limits on application
(d) Avoid the likelihood of foul air or gases accumulating or entering the building, (e) Avoid the likelihood of the spread of fire beyond the refuse chute, (f) Have openings that allow waste to be safely deposited in the chute, and (g) Restrict access by children, animals and vermin. G15.3.3 Where it is acceptable to the network utility operator, solid waste which has been suitably treated for disposal to a sewer may be discharged via a foul water drain complying with Clause G13 "Foul Water".

Provisions

Limits on application

(d) Avoid the likelihood of foul air or gases accumulating or entering the building,

(e) Avoid the likelihood of the spread of fire beyond the refuse chute,

(f) Have openings that allow waste to be safely deposited in the chute, and

(g) Restrict access by children, animals and vermin.

G15.3.3 Where it is acceptable to the network utility operator, solid waste which has been suitably treated for disposal to a sewer may be discharged via a foul water drain complying with Clause G13 "Foul Water".

4

clause-g15PDF 第 5 页 · 原页码 5

	Page
References	7
Definitions	9
Verification Method G15/VM1	11
Acceptable Solution G15/AS1	13
1.0 Capacity of Containers and Storage Areas	13
2.0 Carry Distance	13
3.0 Solid Waste Storage Areas	14
3.1 Alternative acceptable solution	14
4.0 Solid Waste Chutes	14
Index	17

References

For the purposes of New Zealand Building Code compliance, acceptable reference documents include only the quoted edition and specific amendments as listed below.

Amend 1 Sep 1993

Standards New Zealand	Where quoted
NZS 3114: 1987 Specification for concrete surface finishes Amend: 1	AS1 3.0.2
NZS 4304: 1990 Health care waste management	AS1 3.1.1

6

clause-g15

标准信息

标准简介

中文简介

English summary

标准内容预览

References

Status of Compliance Documents

Document Status

New Zealand Building Code Clause G15 Solid Waste

FIRST SCHEDULE–continued

Contents

References

原文图片预览

下载标准文件