消防软管卷盘的安装

Australian Standard^TM

Installation of fire hose reels

1

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

This Australian Standard was prepared by Committee FP-007, Fire Hose Reels. It was approved on behalf of the Council of Standards Australia on 27 October 2005. This Standard was published on 24 November 2005.

The following are represented on Committee FP-007:

• Australian Building Codes Board
• Australasian Fire Authorities Council
• Australian Chamber of Commerce and Industry
• Association of Hydraulic Services Consultants Australia
• Certification Interests (Australia)
• Fire Protection Association Australia
• Fire Protection Association, New Zealand
• Insurance Council of New Zealand
• New Zealand Fire Equipment Association
• Property Council of Australia
• Telstra Corporation

Keeping Standards up-to-date

Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased.

Detailed information about Standards can be found by visiting the Standards Web Shop at www.standards.com.au and looking up the relevant Standard in the on-line catalogue.

Alternatively, the printed Catalogue provides information current at 1 January each year, and the monthly magazine, The Global Standard, has a full listing of revisions and amendments published each month.

Australian Standards^TM and other products and services developed by Standards Australia are published and distributed under contract by SAI Global, which operates the Standards Web Shop.

We also welcome suggestions for improvement in our Standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. Contact us via email at mail@standards.org.au, or write to the Chief Executive, Standards Australia, GPO Box 476, Sydney, NSW 2001.

This Standard was issued in draft form for comment as DR 05069.

3

Australian Standard^TM

Installation of fire hose reels

First published as part of AS CA18—1968.
Revised and redesignated as part of AS 1851.2—1976.
AS 1851.2—1976, revised and redesignated AS 2441—1981.
Fourth edition 2005.

COPYRIGHT

© Standards Australia

All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher.

Published by Standards Australia, GPO Box 476, Sydney, NSW 2001, Australia

ISBN 0 7337 7009 6

4

PREFACE

This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee FP-007, Fire Hose Reels, to supersede AS 2441—1988.

After consultation with stakeholders in both countries, Standards Australia and Standards New Zealand decided to develop this Standard as an Australian Standard rather than an Australian/New Zealand Standard.

The objective of this Standard is to provide users of fire hose reels with specific requirements for their installation. It provides requirements for the protection of fire hose reels in external situations, mounting requirements and clarifies the commissioning procedure.

This edition includes the following changes:

(a) Additional terms defined for clarity.

(b) Flow rates clearly mentioned for different sizes.

(c) New requirements to protect the pipes from mechanical damage and low temperature.

This Standard will be referenced in the Building Code of Australia 2006 (BCA 2006) thereby superseding AS 2441—1988, which will be withdrawn 12 months from the date of publication of this Standard.

Notes to the text contain information and guidance. They are not an integral part of the Standard.

5

CONTENTS

6