JB/T 9158.10-1999 Dimensions of cutting tool holder for horizontal multi-spindle automatic lathe

JB/T 9158.10-1999 JB/T 9158.10-1999 Horizontal multi-spindle automatic lathe auxiliary tool cutting reverse clamp dimensions JB/T9158.10-1999 Standard download decompression password: www.bzxz.net

1CS 25.080.01
Machinery Industry Standard of the People's Republic of China
JB/T9158.1~9158.13—1999Www.bzxZ.net
Accessories of multi-spindle horizuntal automatic lathes
Accessories of multi-spindle horizuntal automatic lathes1999-05-20 Issued
National Machinery Industry Bureau
Implementation on 2000-01-01
Machinery Industry Standard of the People's Republic of China
Accessories of miti-apindie horiznntal automatle lathesReveraalpostforcut-orf-DimensinngThis standard specifies the types and sizes of cutting tools for horizontal multi-spindle automatic lathes. 2 Cited standards
JB/T9158.10—1999
Generation 7.H/T152012.10—90
The provisions contained in the following standards constitute the provisions of this standard through reference in the water standard. When this standard is published, the versions shown are valid. All standards are subject to revision. Parties using non-standards should explore the possibility of using the latest versions of the following standards: GR No. 15R1996 Machine Tools 1. T-shaped bolts and corresponding bolt types and sizes
Types and sizes are as shown in the following figure and table. Approved by the National Machinery Industry Bureau on 1999-0S-20 and implemented on 2000-01-01
4 Building record
Marking example:
Body size
Limit deviation
180158.10-194
F-55mm, 3mm cutting reverse knife fire mark 30
Reverse fire 55×39158.10—1999
Applicable to A machine definition
C2132.611
.2161.6
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.