JB/T 8111-1999 Basic parameters of bladder-type air cushion disc

JB/T 8111-1999 This standard is a revision of JB/T 8111.1-95 "Basic parameters of bladder-type air cushion discs". During the revision, only editorial changes were made according to relevant regulations, and the main technical content remained unchanged. This standard applies to bladder-type air cushion discs; bladder-type air cushion discs can also be used as water cushions. This standard was first published in 1983 as GB 3732-83 and was adjusted to JB/T 8111.1-95 in April 1996. JB/T 8111-1999 Basic parameters of bladder-type air cushion discs JB/T8111-1999 Standard download decompression password: www.bzxz.net

1CS55.180.20
Machinery Industry Standard of the People's Republic of China
JB/T8111-1999
Bladder type air cushion
Basic parameters
Bladder type air pad Basic parameters1999-06-28 Issued
National Machinery Industry Bureau
2000-01-01 Implementation
1B/T8111-1999
This standard is a revision of D/T811.1-95 "Basic parameters of bladder type air cushion". During the revision, the original standard was edited and the main technical content remained unchanged
This standard replaces B/T8111.1-95 from the date of implementation. This standard is proposed and managed by Beijing Hoisting and Transportation Auxiliary Machinery Research Institute. The drafting unit of this standard: Beijing Heavy Transportation Machinery Research Institute. This standard is mainly drafted by: Gao Quan, Dai Yubei, Chu Quan, Zhang Yi, Zhang Jingxiang, Scope
Machinery Industry Standard of the People's Republic of China
Bladder type nirpid Basit parameters This standard applies to type air cushion disc: sleeve type air cushion disc can also be used as water cushion, 2 basic parameters
The basic parameters of the air cushion disc also meet the requirements of the following figure and table. Opening
Nominal diameter D
Density rating
Note: The values ​​in brackets are applicable to dry stamping type loading discs. Guokang Machinery Industry Bureau 1999-06-28 reported the standard hot glue quantity
medical pressure products
cut-off height is
40 (25)
50 (25)
70 (30)
5 (30)
"burning height H
-60 (45)
~70 (50)
-95 (70)
140 (90)
JR/TSIII-1999www.bzxz.net
borrowed B811].1—95
intake pipe
intake vent D
2000-01-01 implementation
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.