JB/T 9950-1999 Parameters of woodworking sawing machine with movable worktable

JB/T 9950-1999 This standard is a revision of ZB J65 009-89 "Parameters of woodworking sawing machines with movable worktables". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies the parameters of woodworking sawing machines with movable worktables. This standard is applicable to woodworking sawing machines with movable worktables with a maximum processing length greater than or equal to 2000mm. This standard was first issued on March 30, 1989. JB/T 9950-1999 Parameters of woodworking sawing machines with movable worktables JB/T9950-1999 standard download decompression password: www.bzxz.net

CS79.120.10
Machinery Industry Standard of the People's Republic of China
JB/T9950-1999
Woodworking Saw Machine with Moving Worktable
1999-05-14 Issued
National Bureau of Machinery Industry
2(HI0-0)-Implementation
JH/T9950-[999
Parameters" revision, only in accordance with the relevant provisions of this standard for 2B165009R9≤1. ... The drafters of this standard are Liu Kako, Ma Xiangwen, Zheng Caijian. This standard was issued on March 30, 1989. The standard specifies the parameters of woodworking sawing machines with a movable workbench. This standard is applicable to woodworking sawing machines with a movable workbench and a maximum depth of 2000 mm. The machine tool type is shown in Figure 1 (without limiting its material). The parameters should comply with the provisions of Table 1. JB/T9950-1999 [t 2B [65 c0)—8]
1-bevel calcium Ning board: 2 oxygen support bevel saw has degree display assembly, 4-do dew guide plate: 5-bed: 6-main adhesive sheet 7 to note guide plate; 8 draw load sheet: 9 fixed 1. workpiece: 10-moving 1 drawing 1
three-state number guide
largest such as Changan
round home machinery industrial fan 1999.05-14 approved 20ko
2000-01-0 1 Implementation
JBrr9950-1999
Appendix AbzxZ.net
【Appendix of Prompt】
Other basic integers of the sawing machine with movable worktable A1Other basic integers of the sawing machine with movable worktable A1. A1
Minimum teaching name
Unfamiliar point 1. Length
The total length is 1 original length
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.