JB/T 8344-1996 Accuracy of woodworking glue coating machine

This standard specifies the requirements and inspection methods for the geometric accuracy and working accuracy of woodworking glue coating machines. JB/T 8344-1996 Woodworking glue coating machine accuracy JB/T8344-1996 Standard download decompression password: www.bzxz.net

Machinery Industry Standard of the People's Republic of China
JB/T 8344—96
Woodworking Gluing Machine
Published on April 11, 1996
Implementation from January 1, 1996
Ministry of Machinery Industry of the People's Republic of China
Machinery Industry Standard of the People's Republic of China
Precision of Woodworking Gluing Machine
1 Subject content and scope of application
This standard specifies the requirements and inspection methods for the accuracy and working accuracy of woodworking glue coating machines. This standard is applicable to these glue coating machines (hereinafter referred to as machine tools). 2 Referenced standardswww.bzxz.net
JB I 1 Accuracy inspection pass for these machine tools
3 Short requirements
3.1 When using this standard, refer to Figure B4171. JB/T 8344 - 96
3.2 Before the machine tool is repaired, the installation water level of the machine tool should be adjusted according to Article 3.1 of JB417. When the water level gauge is installed on the machine tool, the longitudinal and full-axis feed rates should be more than 0.10/1000
3.3 The order of inspection items listed in this standard does not represent the actual inspection order. For the convenience of assembly and disassembly inspection and inspection, the inspection can be carried out in a different order.
3.1 When the actual length is different from the length specified in this standard, the tolerance shall be calculated according to the provisions of 15417112.1.1.1 according to the measurable length. The minimum tolerance value is also c,01mm.
4 Geometric accuracy inspection
Test list 1.
Approved by the Ministry of Machinery Industry on April 11, 1996
Implemented in October 1996
Note: For the clean rubber sown in the north, check Ji 1 (two JB/T 8344-96
Test the main purpose
straightness
state rubber chrysanthemum washing
monitor the radial
diameter
medical jump method
implementation of the diameter
four-row dynamic
rubberized according to the axis
parallelism
pro-comparison according to the axis and the quality research
parallelism
adjustment tool
hao indicator
indicator
horizontal collection
This level only
standard test method to take
JB4171 relevant article
4- 2. 1. 2. 2. 2
4.2.1-2.2
4. 5. 2. 2
In the center of glue killing
4-8. 2. 2
In the middle of glue application
And both sides of the test
4.4.1.2.21
In the state of danger
4. 4. 1. 2. 3. 1
4. 4.1. 7. 4. 5
5Work accuracy inspection
Work type qualification inspection summary table 2.
Additional instructions:
JB/T 8344.--6
before cutting or
permitted
363mum X.62
neither
north face
overlap
central
national
medical
national
machine tools
and||can||have
standards
provided||by
standards
standards
are ... 1. The machine tool set is entrusted by Fuzhou Institute of Technology. The standard is drafted by Gao Nanmo Engineering Institute. The standard is drafted by Haohua, An Xuequn and Wang Zhuanhong. The company's price is based on the relevant provisions of B4171. The quality of each section is the most important quality before and after the test. The commercial value of the small group of fake stocks is the best.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.