JB/T 8030-1999 Machine tool fixture parts and component support plates

JB/T 8030-1999 This standard is a revision of JB/T 8030-95 "Support plates for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies support plates with specifications of M6~M16. This standard was first issued in 1981 as GB 2237-80, first revised to GB/T 2237-91 on April 30, 1991, and adjusted to JB/T 8030-95 in April 1996. JB/T 8030-1999 Support plates for machine tool fixture parts and components JB/T8030-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
2000-01-01 Implementation
1 Scope
Machinery Industry Standard of the People's Republic of ChinawwW.bzxz.Net
The parts and units of jigs and fixturesPlate-type supporters
This standard specifies the support plates with specifications of M6~M16. 2 Referenced standards
JB/T8030—1999
Replaces JB/T8030-1995
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T6991988 Technical conditions for high-quality carbon cable structural steel JB/T8044-1999 Technical requirements for machine tool fixture parts and components 3 Dimensions
The dimensions are shown in the following figure and table.
Approved by the State Machinery Industry Bureau on August 6, 1999 210
Implemented on January 1, 2000
4 Technical conditions
4.1 Material: 45 steel in accordance with the provisions of GB/T699. 4.2 Heat treatment: 35~40HRC.
4.3 Other technical conditions shall be in accordance with the provisions of JB/T8044. 5 Marking
5.1 Marking example:
Support plate with d=M8, L=30mm:
Support plate M8×30JB/T8030—1999
JB/T8030-1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.