JB/T 8014.1-1999 Small locating pins for machine tool fixture parts and components

JB/T 8014.1-1999 JB/T 8014.1-1999 Small locating pins for machine tool fixture parts and components JB/T8014.1-1999 Standard download decompression password: www.bzxz.net

IC5 28.060.41www.bzxz.net
Standard of the Machinery Industry of the People's Republic of China
Parts and components of jigs and fixtures
Issued on August 6, 1999
State Bureau of Machinery Industry
Implemented on January 1, 2000
Standard of the Machinery Industry of the People's Republic of ChinaMachinery nose parts and components
Small locating pins
'Fbr parts and units or jigs and fixtoresSmail locating pin
This standard specifies small locating pins with specifications of 1 to 3 mm. 2 Reference standards
Generation J15:8419
The provisions contained in the following standards are cited in this standard and constitute the provisions of this standard. When this standard is published, all versions shown are valid. All standards may be revised, and parties using this standard should explore the possibility of using the new version of the following standards. GB/1298—1986 Carbon steel parts JB/T 8044—1999 3 Dimensions Technical requirements for machine tool parts and components As shown in the following figure and table, approved by the State Machinery Industry Bureau on August 6, 1999 Implemented on January 1, 2000 Note: D is subject to the public trial implementation decision 4 Technical conditions 4.1 Material: T8 in accordance with the provisions of 1298 4.2 Processing: 55 - 60 HRC
JB/T8014.1-1999
Basic size
4.3 Other technical conditions and specifications of JBT8044 5 markings
5.1 Marking:
Type A small pin with tolerance:
Locate pin A2.57JB8014.1=1999
School limit ticket
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.