
CJ 3020-1993 Drinking Water Source Quality Standard
time:
2024-08-07 13:32:03
- CJ 3020-1993
- in force
Standard ID:
CJ 3020-1993
Standard Name:
Drinking Water Source Quality Standard
Chinese Name:
生活饮用水水源水质标准
Standard category:
Urban construction industry standards (CJ)
-
Date of Release:
1993-08-02 -
Date of Implementation:
1994-01-01
China Standard Classification Number:
Medicine, Health, Labor Protection>>Health>>C51 Environmental Health
Drafter:
Xu Guangxiang, Jiang YuntongDrafting Organization:
China Municipal Engineering Central South Design InstituteFocal point Organization:
Ministry of Construction Water Quality Standard Technical Management Unit China Municipal Engineering Central South Design InstituteProposing Organization:
Standard and Quota Research Institute of the Ministry of ConstructionPublishing Department:
Ministry of Construction of the People's Republic of China

Skip to download
Summary:
This standard specifies the water quality index, water quality classification, standard limit, water quality inspection and supervision and implementation of drinking water sources. This standard applies to the water quality of urban and rural centralized drinking water sources (including the water sources of drinking water prepared by each unit). The water quality of decentralized drinking water sources should also be used as a reference. CJ 3020-1993 Drinking Water Source Water Quality Standard CJ3020-1993 Standard Download Decompression Password: www.bzxz.net

Some standard content:
The People's Republic of China Urban Construction Industry Standard Water quality standard for drinking water sources 1 Subject content and scope of application CJ3020-1993 This standard specifies the water quality indicators, water quality classification, standard limits, water quality inspection and supervision and implementation of the standard for drinking water sources. This standard applies to the water quality of urban and rural centralized drinking water sources (including the water sources of drinking water prepared by each unit). The water quality of decentralized drinking water sources should also be used as a reference. Reference standards GB5749 Sanitary standard for drinking water GB8161 Sanitary standard for beryllium in drinking water source water GB11729 Sanitary standard for chlorothalonil in water source water Standard test method for drinking water GB 5750 Classification of drinking water source water quality The water quality of drinking water sources is divided into two levels, and the limits of the two levels are shown in Table 1. Table 1
Turbidity
Oh and smell
Total hardness (calculated as calcium carbonate)
Dissolved iron
Volatile phenol (calculated as phenol)
Anionic synthetic detergent
Sulfate
Chloride
(degrees)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
|(mg/L)
(mg/L)
(mg/L)
(mg/L)
Standard limit
Color shall not exceed 15 degrees, and shall not show other colors3
No strange smell or odor
Approved by the Ministry of Construction of the People's Republic of China on August 2, 1993. No obvious other colors
No obvious strange smell or odor
6. 5~~8. 5
Implemented on January 1, 1994
Total dissolved solids
Fluoride
Cyanide
Chromium (hexavalent)
Ammonia nitrogen (in terms of nitrogen)
Nitrate (in terms of nitrogen)
Oxygen consumption (KMnO4 method)
Benzo(α)pyrene
DYINGTE
Chlorothalonil
Total coliform bacteria
Total α radioactivity
Total β radioactivity
(mg/L)
(mg/L)
(mg/L)bzxz.net
( mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)|| tt | 000 2
Standard limit
≤10.000
3.1First-level water source: good water quality. Groundwater only needs disinfection treatment, and surface water can be used for drinking after simple purification treatment (such as filtration) and disinfection.
3.2Second-level water source: water quality is slightly polluted. After conventional purification treatment (such as flocculation, sedimentation, filtration, disinfection, etc.), its water quality can meet the requirements of GB5749 and can be used for drinking. 3.3 Water source water with water quality concentration exceeding the second-level standard limit is not suitable as a source of drinking water. If it is necessary to use it due to limited conditions, it should be treated with corresponding purification technology. The treated water quality should meet the requirements of GB5749 and obtain approval from the provincial, municipal and autonomous region health departments (bureaus) and competent departments.
Standard limit
The water quality of drinking water sources should not exceed the limit specified in Table 1. 4.1
4.2 If the water source contains harmful substances not listed in Table 1, relevant regulations shall be followed. 5 Water quality inspection
5.1 The water quality inspection method shall be implemented in accordance with GB5750. The inspection method for beryllium shall be implemented in accordance with GB8161. The inspection method for chlorothalonil shall be implemented in accordance with GB11729.
CJ 3020--1993
This standard shall not be used based on a single instantaneous test value. For the used water source or when selecting a water source, samples shall be taken at least once a quarter for full analysis and inspection. 5.3
6 Supervision and implementation of standards
6.1 This standard shall be implemented by the relevant units such as urban and rural planning, design and drinking water supply. The competent departments of drinking water supply units and health departments shall be responsible for supervising and inspecting the implementation. 6.2 The public security, planning, health, environmental protection, water conservancy and shipping departments at all levels shall cooperate with the water supply units to do a good job in protecting the water source health protection zone in accordance with their respective duties.
Additional Notes:
This standard was proposed by the Standard and Norm Research Institute of the Ministry of Construction. This standard is managed by the China Municipal Engineering Central South Design Institute, the technical unit responsible for water quality standards of the Ministry of Construction. This standard was drafted by the China Municipal Engineering Central South Design Institute. The main drafters of this standard were Xu Guangyang and Jiang Yuntong. This standard was entrusted to the China Municipal Engineering Central South Design Institute for interpretation. 247
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
Turbidity
Oh and smell
Total hardness (calculated as calcium carbonate)
Dissolved iron
Volatile phenol (calculated as phenol)
Anionic synthetic detergent
Sulfate
Chloride
(degrees)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
|(mg/L)
(mg/L)
(mg/L)
(mg/L)
Standard limit
Color shall not exceed 15 degrees, and shall not show other colors3
No strange smell or odor
Approved by the Ministry of Construction of the People's Republic of China on August 2, 1993. No obvious other colors
No obvious strange smell or odor
6. 5~~8. 5
Implemented on January 1, 1994
Total dissolved solids
Fluoride
Cyanide
Chromium (hexavalent)
Ammonia nitrogen (in terms of nitrogen)
Nitrate (in terms of nitrogen)
Oxygen consumption (KMnO4 method)
Benzo(α)pyrene
DYINGTE
Chlorothalonil
Total coliform bacteria
Total α radioactivity
Total β radioactivity
(mg/L)
(mg/L)
(mg/L)bzxz.net
( mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)
(mg/L)|| tt | 000 2
Standard limit
≤10.000
3.1First-level water source: good water quality. Groundwater only needs disinfection treatment, and surface water can be used for drinking after simple purification treatment (such as filtration) and disinfection.
3.2Second-level water source: water quality is slightly polluted. After conventional purification treatment (such as flocculation, sedimentation, filtration, disinfection, etc.), its water quality can meet the requirements of GB5749 and can be used for drinking. 3.3 Water source water with water quality concentration exceeding the second-level standard limit is not suitable as a source of drinking water. If it is necessary to use it due to limited conditions, it should be treated with corresponding purification technology. The treated water quality should meet the requirements of GB5749 and obtain approval from the provincial, municipal and autonomous region health departments (bureaus) and competent departments.
Standard limit
The water quality of drinking water sources should not exceed the limit specified in Table 1. 4.1
4.2 If the water source contains harmful substances not listed in Table 1, relevant regulations shall be followed. 5 Water quality inspection
5.1 The water quality inspection method shall be implemented in accordance with GB5750. The inspection method for beryllium shall be implemented in accordance with GB8161. The inspection method for chlorothalonil shall be implemented in accordance with GB11729.
CJ 3020--1993
This standard shall not be used based on a single instantaneous test value. For the used water source or when selecting a water source, samples shall be taken at least once a quarter for full analysis and inspection. 5.3
6 Supervision and implementation of standards
6.1 This standard shall be implemented by the relevant units such as urban and rural planning, design and drinking water supply. The competent departments of drinking water supply units and health departments shall be responsible for supervising and inspecting the implementation. 6.2 The public security, planning, health, environmental protection, water conservancy and shipping departments at all levels shall cooperate with the water supply units to do a good job in protecting the water source health protection zone in accordance with their respective duties.
Additional Notes:
This standard was proposed by the Standard and Norm Research Institute of the Ministry of Construction. This standard is managed by the China Municipal Engineering Central South Design Institute, the technical unit responsible for water quality standards of the Ministry of Construction. This standard was drafted by the China Municipal Engineering Central South Design Institute. The main drafters of this standard were Xu Guangyang and Jiang Yuntong. This standard was entrusted to the China Municipal Engineering Central South Design Institute for interpretation. 247
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
- Recommended standards
- GB/T 8546-1987 Titanium-stainless steel composite plate
- GB/T 18353-2001 Basic technical condition of cotton processing enterprise
- GB 4738.1-1984 Determination of acid and alkali resistance of daily-use ceramic materials (block method)
- GBZ 68-2002 Diagnostic criteria for occupational benzene poisoning
- NY/T 5054-2002 Technical specification for breeding of Nile tilapia for pollution-free food
- GB 449-1984 Sawn timber volume table
- CJJ/T 52-1993 Technical specification for aerobic static composting of municipal solid waste
- GB/T 5224-2003 Steel strand for prestressed concrete
- GB/T 11606.12-1989 Environmental test methods for analytical instruments - Mildew test
- JG/T 3028-1995 Residential kitchen exhaust duct
- QB/T 2258-1996 Mechanical bell timer
- JB/T 7680-2002 HP bowl type coal mill
- GB/T 15250-1994 Test method for acoustic wave attenuation of piezoelectric lithium niobate single crystal
- GB/T 4789.5-2003 Microbiological examination of food hygiene - Shigella test
- JB/T 8330.1-1996 CNC profile fixed beam gantry boring and milling machine accuracy
Please remember: "bzxz.net" is the combination of the first letters of the Chinese pinyin of the four Chinese characters "standard download" and the international top-level domain name ".net". ©2024 Standard download websitewww.bzxz.net Mail:bzxznet@163.com