JB/T 1308.12-1999 PN250a Locating ring types, dimensions and technical requirements

JB/T 1308.12-1999 This standard is a revision of JB 1319-73 "Pg (2500kgf/cm2) locating ring type, size and technical requirements". This standard specifies the type, size and technical requirements of locating rings for ultra-high pressure valves. This standard is applicable to locating rings for neutral media such as ethylene and polyethylene with a nominal pressure of 250MPa. This standard was first published on 2010-03-19. JB/T 1308.12-1999 PN250a locating ring type, size and technical requirements JB/T1308.12-1999 Standard download decompression password: www.bzxz.net

ICS23.060
Standard of the Machinery Industry of the People's Republic of China
JB/T1308.1~1308.21-1999
PN250MPa ultrahigh pressure valves and fittings
Technical conditions
Specifications for PN250MPa ultrahigh pressure valves and fittings
Published on 1999-07-12
National Bureau of Machinery Industry
Implementation on 2000-01-01
Standard of the Machinery Industry of the People's Republic of China
PN250MPa positioning rings
Type, dimensions and specificationsof PN250 MPa positioning ringsThis standard specifies the type, dimensions and technical requirements of positioning rings for ultrahigh pressure valves. This standard applies to positioning rings for neutral media such as ethylene and polyethylene with a nominal pressure of PN250MPa. 2 Reference standardswwW.bzxz.Net
JB/T1308.12-1999
Replaces JB1319-73
The provisions contained in the following standards constitute the provisions of this standard through reference in this standard. When this standard is published, the version 4 shown is valid. All standards will be revised, and parties using this standard should explore the possibility of using the latest version of the following standards. GB/T 700-1988
Carbon structural steel
JB/T1308.2-1999PN250MPaTechnical conditions for valves, pipe fittings and fastenersStructural types and dimensions
The type of locating ring shall be as specified in Figure 1.
3.2The dimensions of the locating ring shall be as specified in Table 1. Nominal diameter
National Machinery Industry Bureau 1999-07-12 Approved deviation
2000-01-01 Implementation
4 Technical requirements
JB/T1308.12—1999
4.1 Locating ring material A3, technical requirements in accordance with GB/T700. 4.2 Locating ring should be chemically treated to prevent atmospheric erosion. 4.3 Other technical requirements in accordance with JB/T1308.2. 5 Marking example
Locating ring with nominal diameter 20mm:
Locating ring DN20JB/T1308.12—1999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.