GB/T 5335-1985 Connectors for hydraulic testing of automobile brake systems

This standard specifies the main dimensions of connectors used to check the reaction time and pressure value of brake devices of road vehicles (except cars and variants). In order to ensure no leakage and thus ensure the good function of the brake system, the installation of the hydraulic test connector should be able to remove the sealing cover and connect the test instrument for testing without external torsion and bending stress at the test point. This standard is only applicable to hydraulic brake systems. GB/T 5335-1985 Connectors for hydraulic testing of automobile brake devices GB/T5335-1985 Standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Automobile hydraulic pressure test connection for braking equipment
UDC 629.113.01
GB 5885--85
ISO 3808-1976
This standard is equivalent to the international standard ISO3803-1976 "Road vehicles-Hydraulic test connector for braking equipment". 1 Scope of application
This standard specifies the main dimensions of the connector used to check the reaction time and pressure value of the braking equipment of road vehicles (except sedans and modified vehicles).
In order to ensure that there is no leakage and thus ensure the good function of the braking system, the installation of the hydraulic test connector should be able to remove the sealing cover and connect the test instrument for testing without applying torsion and bending stress at the test point. This standard is only applicable to hydraulic braking systems.
2 Main dimensions of the connector
The wrench opening size is 22
Reference surface
Sealing ring in the sealing cover
Dimensions not specified shall be determined by the manufacturing department according to the usage. Installation position: The connector thread for installing the test instrument must be located above the brake pipe joint (that is, the thread must face upward). The test connector can be placed between the wheel cylinder and the master cylinder as required. National Bureau of Standards Issued on August 31, 1985
Implemented on May 1, 1986
3 The free space to be left around the hydraulic test connector is shown in Figure 2.
Enter from above
$120mi
Additional instructions:
GB5335-85
Enter from the side
Reference surface·www.bzxz.net
This standard was proposed by the Ministry of Machinery Industry of the People's Republic of China and is under the jurisdiction of Changchun Automobile Research Institute. This standard was drafted by Nanjing Automobile Manufacturing Plant. The main drafters of this standard are Bao Yumao and Zhu Xiao. * The reference plane must be consistent with the reference plane shown in Figure 1 of Chapter 2. 14.9
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.