JB/T 3411.103-1999 7:24 Dimensions of short intermediate sleeves for cone/Morse cone

JB/T 3411.103-1999 This standard is a revision of JB 3514-83 "7:24 Taper/Morse Taper Short Intermediate Sleeve Dimensions". Only the following points were modified during the revision, and the main technical content remained unchanged: - Writing format; - Standard name plus English; - Relevant reference standards and related content; - Thread drawing method. This standard specifies the type and size of 7:24 Taper/Morse Taper Short Intermediate Sleeves. JB/T 3411.103-1999 7:24 Taper/Morse Taper Short Intermediate Sleeve Dimensions JB/T3411.103-1999 Standard download decompression password: www.bzxz.net

IC5 25.00.01
Mechanical Industry Standard of the People's Republic of China
IB/T 3411.101-3411.127—1999 Accessories for milling machines
Accessories afmilling maclhincs1999-05-2U Issued by
National Machinery Industry Bureau
2000-01-01 Implementation
1 Scope
Mechanical Industry Standard of the People's Republic of China
24 cone/grass bottom cone short intermediate sleeve
Short changing diaeier hnsh with 7:2 lapermose taper
Dinmelsinns
This standard specifies the test dimensions of the 24 mesh tank without payment. 2 Reference standards
JE/134E1.103—1999
J6514-83
The following standards contain the following documents: This standard is for use in accordance with the requirements of this standard. This standard is published and the edition shown is valid. All parts of the standard are slightly revised. The above editions should not be used without notice. 383T1983
Remember wood and. 1. Used to read chain
7: Called to the sex linking worker its dimension
[R7111.351999 bed Sichuan rent size
Type and size
Open type has small people according to the picture and table, this and medical Xiong
bed pull rodWww.bzxZ.net
National Machinery Industry Week 1999-05-20 approved 2H-U1-01 implementation
JR/T3411.103-1999
724 chain and efficiency 3
2 low round who size small difference slow GA5 must be investigated. 4 mark
you remember example:
export is 7: round dimension 10: internal Vickers different year? 2 of 7:24 Dimensional reduction view of the circular chain of the middle room set -2341.1031999
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.