JB/T 8010.14-1999 Machine tool fixture parts and components hinge clamps

JB/T 8010.14-1999 This standard is a revision of JB/T 8010.14-95 "Hinged pressure plates for machine tool fixture parts and components". During the revision, only editorial changes were made according to relevant regulations, and the technical content remained unchanged. This standard specifies hinged pressure plates with specifications of 6 to 28 mm. This standard was first issued in 1981 as GB 2188-80, first revised to GB/T 2188-91 on April 30, 1991, and adjusted to JB/T 8010.14-95 in April 1996. JB/T 8010.14-1999 Hinge pressure plates for machine tool fixture parts and components JB/T8010.14-1999 Standard download decompression password: www.bzxz.net

ICS 25. 080. 01
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixtures
The parts and units of jigs and fixtures1999-08-06 Issued
State Machinery Industry Bureau
2000-01-01 Implementation
1 Scope
Machinery Industry Standard of the People's Republic of China
The parts and units of jigs and fixturesHinged clampplate
This standard specifies the hinged clampplate with a specification of 6~28mm 2 Reference standards
JB/T 8010.14—1999
Replaces JB/T8010.14—1995
The following standards contain provisions that constitute the provisions of this standard through reference in this standard. When this standard is published, the versions shown are valid. All standards will be revised. Parties using this standard should explore the possibility of using the latest versions of the following standards. GB/T6991988
JB/T8044—1999
3 Dimensions
Technical conditions for high-quality carbon structural steel
Technical requirements for machine tool fixture parts and components
The dimensions are shown in the following figure and table.
Approved by the State Bureau of Machinery Industry on August 6, 1999 and implemented on January 1, 2000
Limit Deviation
JB/T 8010.14-1999www.bzxz.net
Basic Dimensions
Limit Deviation
Basic Dimensions
Limit Deviation
4 Technical Conditions
4.1 Material: 45 steel as per GB/T699. JB/T 8010.141999
4.2 Heat Treatment: Type A T215, Type B 35~40HRC. 4.3 Other technical conditions as per JB/T8044. 5 Marking
5.1 Marking example:
A-type hinge pressure plate with L=100mm:
b=8mm,
Pressing plate A8×100JB/T8010.14—199997
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.