GB/T 15120.5-1994 Identification card recording technology Part 5: Location of track 3 of read/write tracks

This standard specifies the track location of the read-write magnetic record (track 3) on the identification card for automatic data exchange. GB/T 15120.5-1994 Identification card recording technology Part 5: Location of track 3 of the read-write track GB/T15120.5-1994 Standard download decompression password: www.bzxz.net

National Standard of the People's Republic of China
Identification cards
Recording technique
Part 5: Location of read-write magnetic track -Track 3Identification cards--- Recording technique-Part 5: Location of read-write magnetic track -Track 3GB/T 15120.5---94
ISO 7811/5—1985
This standard is equivalent to the international standard ISO7811/5-1985 "Identification cards recording technology Part 5: Location of read-write magnetic track -Track 3".
0 Introduction
This standard is one of a series of standards that describe the parameters of the identification cards defined in Chapter 3 below and the identification cards used in international exchange. The recording technique and coded character set for track 3 of digital data are specified in GB/T15120.2. 1 Subject content and scope of application: This standard specifies the track location of read-write magnetic records (track 3) on identification cards using automatic data exchange. 2 Reference standards: GB/T14916 Physical characteristics of identification cards GB/T15120.2 Recording technology of identification cards Part 2: Magnetic stripes 3 Terminology The terminology of "identification cards" given in GB/T14916 applies to this standard. Position of magnetic material The magnetic material should be located in the area shown in Figure 1. Approved by the State Administration of Technical Supervision on July 16, 1994 3.1 Implementation on March 1, 1995 Position of coded data tracks GB/T15120.594 Nearest center edge Magnetic stripe area Position of Track 3 Magnetic Stripe Area
The 3rd track of encoded data shall extend between two lines 12.52mm and 15.32mm from the nearest parallel edge of the card, but the encoding (including the influence of edge effects) shall not extend beyond the line 12.01mm from the nearest parallel edge of the card, or beyond the line 15.82mm from the nearest parallel edge of the card (see Figure 2). wwW.bzxz.Net
Nearest parallel edge
Magnetic stripe area
6 Start of encoding
Track 3
Figure 2 Bit arm of Track 3
The center line of the first data bit (start mark) shall be 7.44±1.00mm from the right side of the card, as shown in Figure 3. 35
Additional instructions;
GB/T15120.5--94
, nearest parallel edge
Magnetic stripe area
7. 14 - 1. o
Figure 3 Position of the first data bit of the third track
This standard is proposed by the Ministry of Machinery and Electronics Industry of the People's Republic of China. This standard is under the jurisdiction of the Electronic Standardization Institute of the Ministry of Machinery and Electronics Industry. This standard was drafted by the Electronic Standardization Institute of the Ministry of Machinery and Electronics Industry and the Financial Technology Department of the People's Bank of China. The main drafters of this standard are Shao Jian, Huang Jiaying, Wang Yunsheng, Liu Zhong, and Nie Shu. From the date of implementation of this standard, the former Ministry of Electronics Industry of the People's Republic of China Standard SJ/Z9026.587 "Identification Card Recording Technology - Part 5: Read and Write Tracks - Positioning of Track 3" will be abolished. 36
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.