Picture image area and photographic sound record on 16mm motion-picture release prints-Positions an

GB/T 5299-1985 Picture area and position and dimensions of optical soundtrack on 16mm motion picture release films GB/T5299-1985 standard download decompression password: www.bzxz.net

Scope of application
National Standard of the People's Republic of China
Picture image areas and photographic sound record on 16mm motion-picture release prints - positions and dimensions1.1 This standard applies to 16mm motion-picture release prints. UDC78.634
GB5299—85
1.2 This standard specifies the picture area on 16mm motion-picture release prints and the position and dimensions of the optical sound track corresponding to the base. 1.3 This standard also specifies the lateral length and position dimensions of the optical blade on the sound track. 2 Positions and dimensions
The position and dimensions of each item are shown in the following figure and table. Through the two centersbzxZ.net
Light force
Excitation light
National Bureau of Standards
Reference edge
Movie running direction
Nominal value
E Reference value
R Maximum
f= (nominal value)
GB 5299—85
To: For variable-area optical soundtracks. ② For variable-density optical soundtracks.
3 To the center line of variable-area or variable-density optical soundtracks. Number
7.42*8.16
1.52-8:08
2.03 ±0.08
14.d8±0.08
13.58 ± 0.03
1.80±0.03
2.2 The recording and reproducing blades should be placed at a position 90±5 to the film reference edge. 2.8 The dimensions listed are for films with a safe film base that does not exceed the allowable shrinkage range. 3 Sound and picture frame distance
For films that are usually shown, the sound track recorded on the film should be in front of the corresponding picture based on the film running direction. According to the provisions of GB2926-82 "Technical Specifications for Title Headers and Ends for 35mm and 16mm Film Distribution Films", the distance from the horizontal center line of the picture to the corresponding sound track should be 26±1 frame. Emulsion surface orientation
When 16mm sound films are projected directly frontally, the process of printing with the emulsion surface facing the projector lens should be preferred. Note: 1mm films can also be produced with the emulsion surface facing the projector light source, but the emulsion surface orientation in the same film should not be different, and the emulsion surface orientation should be indicated on the film box label.
5 Sound reproduction speed
The soundtrack of 16mm sound films should be recorded and reproduced at the normal projection speed of 24 frames per second. Additional notes:
GB 2 99—85
This standard was proposed by the Ministry of Culture of the People's Republic of China and is under the jurisdiction of the China Film Science and Technology Research Institute of the Ministry of Culture. This standard was drafted by the China Film Science and Technology Research Institute of the Ministry of Culture. The main drafter of this standard is Yu Zhengzhong.
This standard is entrusted to the China Film Science and Technology Research Institute of the Ministry of Culture for interpretation.
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.