JB/T 6273.1-1992 Types and basic parameters of rural small drinking water equipment

time: 2024-06-30 09:22:46
  • JB/T 6273.1-1992
  • Abolished

Basic Information

standard classification number

  • China Standard Classification Number:

    Agriculture & Forestry>>Agricultural & Forestry Machinery & Equipment>>B91 Agricultural Machinery

associated standards

Publication information

Other Information

  • Focal point Organization:

    Chinese Academy of Agricultural Mechanization Sciences
Introduction to standardsDescription (Translated English) / download

Skip to download

Summary:

This standard specifies the types, models and basic parameters of rural small-scale soft water equipment. JB/T 6273.1-1992 Types and basic parameters of rural small-scale drinking water equipment JB/T6273.1-1992 Standard download decompression password: www.bzxz.net
Standard contentStandard content

Some standard content:

Mechanical Industry Standard of the People's Republic of China
JB/T6273.1—92
Small rural drinking water equipment
Type and basic parameters
Published on June 10, 1992
Implementation by the Ministry of Machinery and Electronics Industry of the People's Republic of China on July 1, 1993
Mechanical Industry Standard of the People's Republic of ChinawwW.bzxz.Net
Small rural drinking water equipment
Type and basic parameters
Subject content and scope of application
JB/T6273.1—92
This standard specifies the type, model and basic parameters of small rural drinking water equipment (hereinafter referred to as drinking water equipment). This standard applies to drinking water equipment with motor and water pump integrated, flow rate less than 3m/h, ground head 4~12m, suction head (suction head refers to the vertical distance from the underground dynamic water level to the center line of the pump impeller) 6~20m, and matching motor power of 750W and below. 2 Reference Standards
JB/T6273.2 Technical Conditions for Small Rural Drinking Water Equipment3 Types
3.1 Drinking water equipment is divided into two types: automatic operation type and non-automatic operation type. The automatic operation type is composed of a water pump, a motor, a jet pump, a pressure tank and an automatic control system. 3.1.1
3.1.2 The non-automatic operation type is composed of a water pump, a motor and a jet pump. 3.2 Water pumps are divided into centrifugal and vortex types according to the impeller type. 3.3 From the water pump impeller suction population, the pump shaft rotates counterclockwise. 3.4
The water pump and the motor of the drinking water equipment are coaxially connected. 4 Model
Model indication method
4.2 Marking example
The matching water pump is a submersible pump, indicated by Q
Omitted when the matching water pump is other pumps
Suction head, m
Automatic operation type is indicated by Z
Non-automatic operation type is omitted
Suction head is 15m, the matching water pump is a submersible pump, automatic operation type rural small drinking water equipment, its mark is: SYBZ-15QJB/T6273.1—92
Approved by the Ministry of Machinery and Electronics Industry on June 10, 1992 and implemented on July 1, 1993
5 Basic parameters
JB/T6273.1-92
Under the use conditions specified in JB/T6273.2, the basic parameters of drinking water equipment shall comply with the provisions of the following table Flow
SYBZ-6
SYBZ-10
SYBZ-15
SYBZ-20
SYB-10
SYB-15
SYB-20
SYBZ-15Q
SYB-15Q
Note: 1) The suction head value is the head value of the submersible pump. Additional remarks:
Ground head
This standard is proposed and managed by the Chinese Academy of Agricultural Mechanization Sciences. Speed
This standard is drafted by the Institute of Irrigation and Drainage Machinery of the Chinese Academy of Agricultural Mechanization Sciences. The main drafters of this standard are Xu Anxiang and Zhang Qingfan. 2
Matching power
Minimum suitable
Applicable parallel diameter
People's Republic of China
Mechanical industry standard
Rural small drinking water equipment
Type and basic parameters
JB/T6273.192
Published by the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry Printed by the Mechanical Standardization Research Institute of the Ministry of Machinery and Electronics Industry (Beijing 8144 P.O. Box 100081)
Copyright reserved
No reproduction allowed
Format 880×1230
Printing sheet 3/8
Word count 4,000
First printing in June 1993
First edition in June 1993
Price 1.20 yuan
Print run 00.001-500
Tip: This standard content only shows part of the intercepted content of the complete standard. If you need the complete standard, please go to the top to download the complete standard document for free.
Please remember: "bzxz.net" is the combination of the first letters of the Chinese pinyin of the four Chinese characters "standard download" and the international top-level domain name ".net". ©2024 Standard download websitewww.bzxz.net Mail:bzxznet@163.com