高压装置

COMMITTEE EL-043, DR 07281

(Project ID: 4687)

Draft for Public Comment Australian Standard

LIABLE TO ALTERATION—DO NOT USE AS A STANDARD

High voltage installations

(Revision of AS 2067—1984)

1

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

Draft for Public Comment

Australian Standard

The committee responsible for the issue of this draft comprised representatives of organizations interested in the subject matter of the proposed Standard. These organizations are listed on the inside back cover.

Comments are invited on the technical content, wording and general arrangement of the draft.

The preferred method for submission of comment is to download the MS Word comment form found at http://www.standards.com.au/Catalogue/misc/Public%20Comment%20Form.doc. This form also includes instructions and examples of comment submission.

When completing the comment form ensure that the number of this draft, your name and organization (if applicable) is recorded. Please place relevant clause numbers beside each comment.

Editorial matters (i.e. spelling, punctuation, grammar etc.) will be corrected before final publication.

The coordination of the requirements of this draft with those of any related Standards is of particular importance and you are invited to point out any areas where this may be necessary.

Please provide supporting reasons and suggested wording for each comment. Where you consider that specific content is too simplistic, too complex or too detailed please provide an alternative.

If the draft is acceptable without change, an acknowledgment to this effect would be appreciated.

When completed, this form should be returned to the Projects Manager, Eu Jin Loh via email to Eujin.loh@standards.org.au.

Normally no acknowledgment of comment is sent. All comments received electronically by the due date will be put before the relevant drafting committee. Because Standards committees operate electronically we cannot guarantee that comments submitted in hard copy will be considered along with those submitted electronically. Where appropriate, changes will be incorporated before the Standard is formally approved.

If you know of other persons or organizations that may wish to comment on this draft Standard, could you please advise them of its availability. Further copies of the draft are available from the Customer Service Centre listed below and from our website at http://www.standards.org.au/.

STANDARDS AUSTRALIA Customer Service Centre

Telephone: 1300 65 46 46

Facsimile: 1300 65 49 49

e-mail: mailto:sales@standards.com.au

Internet: http://www.standards.com.au/

3

Draft for Public Comment

STANDARDS AUSTRALIA

Committee EL-043—High Voltage Installations

DRAFT

Australian Standard

High voltage installations

(Revision of AS 2067—1984)

(To be AS 2067—200X)

Comment on the draft is invited from people and organizations concerned with this subject. It would be appreciated if those submitting comment would follow the guidelines given on the inside front cover.

This document is a draft Australian Standard only and is liable to alteration in the light of comment received. It is not to be regarded as an Australian Standard until finally issued as such by Standards Australia.

4

PREFACE

This Standard was prepared by the Standards Australia Committee EL-043, High Voltage Installations to supersede AS 2067—1984, Switchgear assemblies and ancillary equipment for attenuating voltages above 1 kV.

The objective of this Standard is to provide common rules for the design and the erection of electrical power installations in systems with nominal voltages above 1 kV a.c and nominal frequency up to and including 60 Hz.

In the preparation of this Standard, consideration was given to IEC 61936-1:2002, Power installations exceeding 1 kV a.c. – Part 1: Common rules, and acknowledgement is made of the assistance received.

Where a reference is made to “national regulations”, it is intended to encompass national, state and local regulations.

The terms ‘normative’ and ‘informative’ are used to define the application of the annex to which they apply. A normative annex is an integral part of a standard, whereas an informative annex is only for information and guidance.

5

CONTENTS

6