AS NZS 2890.1 2004 Parking facilities Part 1 Off-street car parking

CONTENTS

6

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee CE-001, Parking Facilities. It was approved on behalf of the Council of Standards Australia on 12 January 2004 and on behalf of the Council of Standards New Zealand on 23 February 2005.

This Standard was published on 5 March 2004.

The following are represented on Committee CE-001:

• ACT Department of Urban Services
• Association of Consultants in Access Australia
• Australian Building Codes Board
• Disabled Persons Assembly New Zealand
• Institute of Public Works Engineering Australia
• Institution of Engineers Australia
• Institution of Professional Engineers New Zealand
• Local Government New Zealand
• Main Roads Department, Queensland
• Monash University
• New Zealand Automobile Association
• Parking Association of Australia
• Property Council of Australia
• Property Council of New Zealand
• Roads and Traffic Authority of NSW

Keeping Standards up-to-date

Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased.

Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Web Shop at www.standards.com.au or Standards New Zealand web site at www.standards.co.nz and looking up the relevant Standard in the on-line catalogue.

Alternatively, both organizations publish an annual printed Catalogue with full details of all current Standards. For more frequent listings or notification of revisions, amendments and withdrawals, Standards Australia and Standards New Zealand offer a number of update options. For information about these services, users should contact their respective national Standards organization.

We also welcome suggestions for improvement in our Standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. Please address your comments to the Chief Executive of either Standards Australia or Standards New Zealand at the address shown on the back cover.

This Standard was issued in draft form for comment as DR 02352.

AS/NZS 2890.1:2004

(Incorporating Amendment No. 1)

Australian/New Zealand Standard™

Parking facilities

Part 1: Off-street car parking

Originated as AS 2890.1—1986.

Previous edition 1993.

Jointly revised and designated as AS/NZS 2890.1:2004.

Reissued incorporating Amendment No. 1 (August 2005).

COPYRIGHT

© Standards Australia/Standards New Zealand

All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher.

Jointly published by Standards Australia, GPO Box 476, Sydney, NSW 2001 and Standards New Zealand, Private Bag 2439, Wellington 6020

ISBN 0 7337 5742 1

4

PREFACE

This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee CE-001, Parking Facilities and supersedes AS 2890.1—1993, Parking facilities, Part 1: Off-street car parking.

This Standard incorporates Amendment No. 1 (August 2005). The changes required by the Amendment are indicated in the text by a marginal bar and amendment number against the clause, note, table, figure or part thereof affected.

It is one of a series of Standards on parking facilities as follows:

The objective of this Standard is to provide planners, designers and regulatory bodies with requirements and recommendations for the design and layout of off-street parking facilities.

The following lists the principal changes and additions to this edition of the Standard:

(a) Publication as a Joint Australia/New Zealand Standard. Where requirements or recommendations apply only to Australia or only to New Zealand, these are indicated in the text or on illustrations.

(b) Addition of two new user classes, the first aimed at relaxing manoeuvre space requirements to reach parking spaces in residential properties and the second, to increase aisle width requirements at certain high turnover parking areas.

(c) Expanded detail on parallel parking in parking aisles.

(d) Changes in ramp grade requirements for private/residential car parks and for parking on domestic properties.

(e) A reappraisal of design vehicle characteristics and dimensions which includes an increase in the minimum vehicle ground clearance from 100 mm to 120 mm.

The terms ‘normative’ and ‘informative’ have been used in this Standard to define the application of the appendix to which they apply. A ‘normative’ appendix is an integral part of a Standard, whereas an ‘informative’ appendix is only for information and guidance.

Statements expressed in mandatory terms in notes to tables and figures are deemed to be requirements of this Standard.

* In preparation. See footnote to Clause 1.2.

5

CONTENTS

6