铝结构焊接

CONTENTS

6

AS IS

内部资料

仅供参考

张忠辉惠存

禁止一切非法目的和活动行为，否则后果自负。

NOT FOR PUBLIC RELEASE

2

AS/NZS 1665:2004

This Joint Australian/New Zealand Standard was prepared by Joint Technical Committee WD-003, Welding of Steel Structures. It was approved on behalf of the Council of Standards Australia on 16 December 2003 and on behalf of the Council of Standards New Zealand on 5 March 2004. It was published on 22 March 2004.

The following are represented on Committee WD-003:

• Australian Chamber of Commerce and Industry
• Australian Industry Group
• AUSTROADS
• Bureau of Steel Manufacturers of Australia
• Electricity Supply Association of Australia
• Institution of Engineers Australia
• New Zealand Heavy Engineering Research Association
• New Zealand Non-destructive Testing Association
• New Zealand Welding School
• Steel Reinforcement Institute of Australia
• University of Sydney
• Welding Technology Institute of Australia

Keeping Standards up-to-date

Standards are living documents which reflect progress in science, technology and systems. To maintain their currency, all Standards are periodically reviewed, and new editions are published. Between editions, amendments may be issued. Standards may also be withdrawn. It is important that readers assure themselves they are using a current Standard, which should include any amendments which may have been published since the Standard was purchased.

Detailed information about joint Australian/New Zealand Standards can be found by visiting the Standards Web Shop at www.standards.com.au or Standards New Zealand web site at www.standards.co.nz and looking up the relevant Standard in the on-line catalogue.

Alternatively, both organizations publish an annual printed Catalogue with full details of all current Standards. For more frequent listings or notification of revisions, amendments and withdrawals, Standards Australia and Standards New Zealand offer a number of update options. For information about these services, users should contact their respective national Standards organization.

We also welcome suggestions for improvement in our Standards, and especially encourage readers to notify us immediately of any apparent inaccuracies or ambiguities. Please address your comments to the Chief Executive of either Standards Australia International or Standards New Zealand at the address shown on the back cover.

This Standard was issued in draft form for comment as DR 02451.

3

Australian/New Zealand Standard™

Welding of aluminium structures

Originated as AS 1665—1976.

Previous edition AS 1665—1992.

Jointly revised and designated AS/NZS 1665:2004.

COPYRIGHT

© Standards Australia/Standards New Zealand

All rights are reserved. No part of this work may be reproduced or copied in any form or by any means, electronic or mechanical, including photocopying, without the written permission of the publisher.

Jointly published by Standards Australia International Ltd, GPO Box 5420, Sydney, NSW 2001 and Standards New Zealand, Private Bag 2439, Wellington 6020

ISBN 0 7337 5736 7

4

PREFACE

This Standard was prepared by the Joint Standards Australia/Standards New Zealand Committee WD-003, Welding of Structures, to supersede AS 1665—1992.

The objective of this Standard is to standardize the welding of aluminium structures and incorporate the latest techniques used in industry.

This is a major revision of the previous edition, including references to the latest materials being used.

The terms 'normative' and 'informative' have been used in this Standard to define the application of the appendix to which they apply. A 'normative' appendix is an integral part of a Standard, whereas an 'informative' appendix is only for information and guidance

Statements expressed in mandatory terms in notes to tables and figures are deemed to be requirements of this Standard.

5

CONTENTS

6